Which command is missing from the IP SLA configuration?

Refer to the exhibit. ISP 1 and ISP 2 directly connect to the Internet. A customer is tracking both ISP links to achieve redundancy and cannot see the Cisco IOS IP SLA tracking output on the router console. Which command is missing from the IP SLA configuration?A . Start-time 00:00B...

September 23, 2021 No Comments READ MORE +

Which statement about IPv6 RA Guard is true?

Which statement about IPv6 RA Guard is true?A . It does not offer protection in environments where IPv6 traffic is tunneled.B . It cannot be configured on a switch port interface in the ingress direction.C . Packets that are dropped by IPv6 RA Guard cannot be spanned.D . It is...

September 23, 2021 No Comments READ MORE +

Which action blocks the route?

Refer to the exhibit. An engineer is trying to block the route to 192.168.2.2 from the routing table by using the configuration that is shown. The route is still present in the routing table as an OSPF route. Which action blocks the route?A . Use an extended access list instead...

September 23, 2021 No Comments READ MORE +

Which two configurations fix the issue?

Refer to the exhibit. Network operations cannot read or write any configuration on the device with this configuration from the operations subnet. Which two configurations fix the issue? (Choose two.)A . Configure SNMP rw permission in addition to community ciscotest.B . Modify access list 1 and allow operations subnet in...

September 23, 2021 No Comments READ MORE +

Which list defines the contents of an MPLS label?

Which list defines the contents of an MPLS label?A . 20-bit label; 3-bit traffic class; 1-bit bottom stack; 8-bit TTLB . 32-bit label; 3-bit traffic class; 1-bit bottom stack; 8-bit TTLC . 20-bit label; 3-bit flow label; 1-bit bottom stack; 8-bit hop limitD . 32-bit label; 3-bit flow label; 1-bit...

September 23, 2021 No Comments READ MORE +

Which command must the engineer run to correct the configuration?

An engineer configured the wrong default gateway for the Cisco DNA Center enterprise interface during the install. Which command must the engineer run to correct the configuration?A . sudo maglev-config updateB . sudo maglev install config updateC . sudo maglev reinstallD . sudo update config installView AnswerAnswer: A

September 23, 2021 No Comments READ MORE +

What is the reason the route is not advertised?

Refer to the exhibit. R2 is a route reflector, and R1 and R3 are route reflector clients. The route reflector learns the route to 172.16.25.0/24 from R1, but it does not advertise to R3. What is the reason the route is not advertised?A . R2 does not have a route...

September 23, 2021 No Comments READ MORE +

Why is the image not uploading?

White working with software images, an engineer observes that Cisco DNA Center cannot upload its software image directly from the device. Why is the image not uploading?A . The device has lost connectivity to Cisco DNA Center.B . The software image for the device is in bundle modeC . The...

September 23, 2021 No Comments READ MORE +

Which configuration denies Telnet traffic to router 2 from 198A:0:200C::1/64?

Refer to the exhibit. Which configuration denies Telnet traffic to router 2 from 198A:0:200C::1/64? A) B) C) D) A . Option AB . Option BC . Option CD . Option DView AnswerAnswer: A

September 22, 2021 No Comments READ MORE +

Which option is the best for protecting CPU utilization on a device?

Which option is the best for protecting CPU utilization on a device?A . fragmentationB . COPPC . ICMP redirectsD . ICMP unreachable messagesView AnswerAnswer: B

September 22, 2021 No Comments READ MORE +