- All Exams Instant Download
Which command must be used in configuration mode to enable SSH on the device?
Refer to the exhibit. An engineer is trying to connect to a device with SSH but cannot connect. The engineer connects by using the console and finds the displayed output when troubleshooting. Which command must be used in configuration mode to enable SSH on the device?A . no ip ssh...
Which action resolves the issue without opening full access to this router?
Refer to the exhibit. The ACL is placed on the inbound Gigabit 0/1 interface of the router. Host 192.168.10.10cannot SSH to host 192.168.100.10 even though the flow is permitted. Which action resolves the issue without opening full access to this router?A . Move the SSH entry to the beginning of...
Which transport layer protocol is used to form LDP sessions?
Which transport layer protocol is used to form LDP sessions?A . UDPB . SCTPC . TCPD . RDPView AnswerAnswer: C Explanation: LDP multicasts hello messages to a well-known UDP port (646) in order to discover neighbors. Once the discovery is accomplished, a TCP connection (port 646) is established and the...
Drag and drop the packet types from the left onto the correct descriptions on the right
DRAG DROP Drag and drop the packet types from the left onto the correct descriptions on the right. View AnswerAnswer: Explanation: Unlike legacy network technologies such as ISDN, Frame Relay, and ATM that defined separate data and control channels, IP carries all packets within a single pipe. Thus, IP network...
Which interface configuration must be configured on the spoke A router to enable a dynamic DMVPN tunnel with the spoke B router?
Refer to the exhibit. Which interface configuration must be configured on the spoke A router to enable a dynamic DMVPN tunnel with the spoke B router? A . Option AB . Option BC . Option CD . Option DView AnswerAnswer: B
Which action blocks the route?
Refer to the exhibit. An engineer is trying to block the route to 192.168.2.2 from the routing table by using the configuration that is shown. The route is still present in the routing table as an OSPF route. Which action blocks the route?A . Use an extended access list instead...
Drag and drop the operations from the left onto the locations where the operations are performed on the right
DRAG DROP Drag and drop the operations from the left onto the locations where the operations are performed on the right. View AnswerAnswer: Explanation: Label Switch Router
Which configuration ensures that the branch router in AS 45123 advertises only the local networks to all SP neighbors?
After some changes in the routing policy, it is noticed that the router in AS 45123 is being used as a transit AS router for several service provides. Which configuration ensures that the branch router in AS 45123 advertises only the local networks to all SP neighbors? A) B) C)...
What is needed to fix the problem?
Refer to the exhibit. During troubleshooting it was discovered that the device is not reachable using a secure web browser. What is needed to fix the problem?A . permit tcp port 443B . permit udp port 465C . permit tcp port 465D . permit tcp port 22View AnswerAnswer: A
Which control plane policy limits BGP traffic that is destined to the CPU to 1 Mbps and ignores BGP traffic that is sent at higher rate?
Refer to the exhibit. Which control plane policy limits BGP traffic that is destined to the CPU to 1 Mbps and ignores BGP traffic that is sent at higher rate?A . policy-map SHAPE_BGPB . policy-map LIMIT_BGPC . policy-map POLICE_BGPD . policy-map COPPView AnswerAnswer: D
