200-301 exam

When a client and server are not on the same physical network, which device is used to forward requests and replies between client and server for DHCP?A . DHCP relay agentB . DHCP serverC . DHCPDISCOVERD . DHCPOFFERView AnswerAnswer: A

Refer to the exhibit. Which change to the configuration on Switch allows the two switches to establish an EtherChannel?A . Change the protocol to EtherChannel mode onB . Change the LACP mode to activeC . Change the LACP mode to desirableD . Change the protocol to PAgP and use auto...

Drag and drop the IPv6 address type characteristics from the left to the right. View AnswerAnswer:

An engineer observes high usage on the 2.4GHz channels and lower usage on the 5GHz channels. What must be configured to allow clients to preferentially use 5GHz access points?A . Client Band SelectB . OEAP Split TunnelC . 11ac MU-MIMOD . Re-Anchor Roamed ClientsView AnswerAnswer: A

Which mode must be set for APs to communicate to a Wireless LAN Controller using the Control and Provisioning of Wireless Access Points (CAPWAP) protocol?A . bridgeB . routeC . autonomousD . lightweightView AnswerAnswer: D

Which 802.11 management frame type is sent when a client roams between access points on the same SSID?A . Authentication RequestB . Probe RequestC . Reassociation RequestD . Association RequestView AnswerAnswer: C

Refer to the exhibit. R5 is the current DR on the network, and R4 is the BDR. Their interfaces are flapping, so a network engineer wants the OSPF network to elect a different DR and BDR. Which set of configurations must the engineer implement? Option A R4(config)#interface gi0/0 R4(config-if)#ip ospf...

Refer to the exhibit. Only four switches are participating in the VLAN spanning-tree process. Branch-1: priority 614440 Branch-2: priority 39082416 Branch-3: priority 0 Branch-4: root primary Which switch becomes the permanent root bridge for VLAN 5?A . Branch-1B . Branch-2C . Branch-3D . Branch-4View AnswerAnswer: C

Refer to the exhibit. An engineer must configure GigabitEthernet1/1 to accommodate voice and data traffic. Which configuration accomplishes this task? Option A interface gigabitethernet1/1 switchport mode access switchport access vlan 300 switchport voice vlan 400 Option B interface gigabitethernet1/1 switchport mode access switchport access vlan 400 switchport voice vlan 300...

Refer to the exhibit. If R1 receives a packet destined to 172.16.1.1, to which IP address does it send the packet?A . 192.168.12.2B . 192.168.13.3C . 192.168.14.4D . 192.168.15.5View AnswerAnswer: C