- All Exams Instant Download
Which two changes stop outbound traffic on TCP ports 25 and 80 to 10.0.20 0 26 from the 10.0.10 0/26 subnet while still allowing all other traffic?
Refer to the exhibit. An extended ACL has been configured and applied to router R2 The configuration failed to work as intended. Which two changes stop outbound traffic on TCP ports 25 and 80 to 10.0.20 0 26 from the 10.0.10 0/26 subnet while still allowing all other traffic? (Choose...
By default, how Does EIGRP determine the metric of a route for the routing table?
By default, how Does EIGRP determine the metric of a route for the routing table?A . it uses the bandwidth and delay values of the path to calculate the route metricB . it uses a default metric of 10 for all routes that are learned by the routerC . it...
Which error must be corrected?
Refer to the Exhibit. After the switch configuration the ping test fails between PC A and PC B Based on the output for switch 1. Which error must be corrected?A . There is a native VLAN mismatchB . Access mode is configured on the switch ports.C . The PCs are...
Which two steps will fulfill the request?
An engineer is asked to protect unused ports that are configured in the default VLAN on a switch. Which two steps will fulfill the request? (Choose two)A . Configure the ports in an EtherChannel.B . Administratively shut down the portsC . Configure the port type as access and place in...
What is the primary purpose of a First Hop Redundancy Protocol?
What is the primary purpose of a First Hop Redundancy Protocol?A . It allows directly connected neighbors to share configuration information.B . It allows a router to use bridge priorities to create multiple loop-free paths to a single destination.C . It reduces routing failures by allowing Layer 3 load balancing...
Which two actions are performed by the Weighted Random Early Detection mechanism? (Choose two)
Which two actions are performed by the Weighted Random Early Detection mechanism? (Choose two)A . It drops lower-priority packets before it drops higher-priority packetsB . It can identify different flows with a high level of granularityC . It guarantees the delivery of high-priority packetsD . It can mitigate congestion by...
What is a difference between local AP mode and FiexConnet AP mode?
What is a difference between local AP mode and FiexConnet AP mode?A . Local AP mode creates two CAPWAP tunnels per AP to the WLCB . FiexConnect AP mode fails to function if the AP loses connectivity with the WLCC . FlexConnect AP mode bridges the traffic from the AP...
Drag and drop the network protocols from the left onto the correct transport services on the right
DRAG DROP Drag and drop the network protocols from the left onto the correct transport services on the right. View AnswerAnswer:
Which IPv6 address block sends packets to a group address rather than a single address?
Which IPv6 address block sends packets to a group address rather than a single address?A . 2000::/3B . FC00::/7C . FE80::/10D . FF00::/8View AnswerAnswer: D Explanation: FF00::/8 is used for IPv6 multicast and this is the IPv6 type of address the question wants to ask. FE80::/10 range is used for...
What occurs to frames during the process of frame flooding?
What occurs to frames during the process of frame flooding?A . Frames are sent to every port on the switch in the same VLAN except from the originating portB . Frames are sent to every port on the switch that has a matching entry in the MAC address table.C ....
