- All Exams Instant Download
Which command is used to specify the delay time in seconds for LLDP to initialize on any interface?
Which command is used to specify the delay time in seconds for LLDP to initialize on any interface?A . lldp timerB . lldp holdtimtC . lldp reinitD . lldp tlv-selectView AnswerAnswer: C Explanation: Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst2960/software/release/12-2_37_ey/configuration/guide/scg/swlldp.pdf + lldp holdtime seconds: Specify the amount of time a receiving device should hold the...
If the network environment is operating normally, which type of device must be connected to interface FastEthernet 0/1?
Refer to the exhibit. ip arp inspection vlan 2-10 interface fastethernet 0/1 ip arp inspection trust If the network environment is operating normally, which type of device must be connected to interface FastEthernet 0/1?A . DHCP clientB . access pointC . routerD . PCView AnswerAnswer: C
When configuring a WLAN with WPA2 PSK in the Cisco Wireless LAN Controller GUI, which two formats are available to select? (Choose two)
When configuring a WLAN with WPA2 PSK in the Cisco Wireless LAN Controller GUI, which two formats are available to select? (Choose two)A . ASCIIB . base64C . binaryD . decimalE . hexadecimalView AnswerAnswer: A, E Explanation: Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-4/configuration/guides/consolidated/b_cg74_CONSOLIDATED/b_cg74_CONSOLIDATED_chapter_010 10001.html
Which command automatically generates an IPv6 address from a specified IPv6 prefix and MAC address of an interface?
Which command automatically generates an IPv6 address from a specified IPv6 prefix and MAC address of an interface?A . ipv6 address dhcpB . ipv6 address 2001:DB8:5:112::/64 eui-64C . ipv6 address autoconfigD . ipv6 address 2001:DB8:5:112::2/64 link-localView AnswerAnswer: C Explanation: The “ipv6 address autoconfig” command causes the device to perform IPv6...
A network engineer is configuring an OSPFv2 neighbor adjacency
DRAG DROP A network engineer is configuring an OSPFv2 neighbor adjacency. Drag and drop the parameters from the left onto their required categories on the right. Not all parameters are used View AnswerAnswer:
Which two standard designs are recommended?
Several new coverage cells are required to improve the Wi-Fi network of an organization. Which two standard designs are recommended? (Choose two.)A . 5GHz provides increased network capacity with up to 23 nonoveriapping channels.B . For maximum throughput, the WLC is configured to dynamically set adjacent access points to the...
What are two benefits of controller-based networking compared to traditional networking?
What are two benefits of controller-based networking compared to traditional networking?A . controller-based increases network bandwidth usage, while traditional lightens the load on the network.B . controller-based inflates software costs, while traditional decreases individual licensing costsC . Controller-based reduces network configuration complexity, while traditional increases the potential for errorsD ....
What is the primary purpose of a First Hop Redundancy Protocol?
What is the primary purpose of a First Hop Redundancy Protocol?A . It allows directly connected neighbors to share configuration information.B . It allows a router to use bridge priorities to create multiple loop-free paths to a single destination.C . It reduces routing failures by allowing Layer 3 load balancing...
Which 802.11 frame type is association response?
Which 802.11 frame type is association response?A . managementB . protected frameC . controlD . actionView AnswerAnswer: A Explanation: Reference: https://en.wikipedia.org/wiki/802.11_Frame_Types
Which mode must be used to configure EtherChannel between two switches without using a negotiation protocol?
Which mode must be used to configure EtherChannel between two switches without using a negotiation protocol?A . onB . autoC . activeD . desirableView AnswerAnswer: A Explanation: The Static Persistence (or “on” mode) bundles the links unconditionally and no negotiation protocol is used. In this mode, neither PAgP nor LACP...
