- All Exams Instant Download
What is the effect of this configuration?
Refer to the exhibit . What is the effect of this configuration?A . The switch port interface trust state becomes untrustedB . The switch port remains administratively down until the interface is connected to another switchC . Dynamic ARP inspection is disabled because the ARP ACL is missingD . The...
Which feature on the Cisco Wireless LAN Controller when enabled restricts management access from specific networks?
Which feature on the Cisco Wireless LAN Controller when enabled restricts management access from specific networks?A . CPU ACLB . TACACSC . Flex ACLD . RADIUSView AnswerAnswer: A Explanation: Reference: https://www.cisco.com/c/en/us/support/docs/wireless-mobility/wlan-security/71978-acl-wlc.html
Which two misconfigurations cause this behavior?
While examining excessive traffic on the network, it is noted that all incoming packets on an interface appear to be allowed even though an IPv4 ACL is applied to the interface . Which two misconfigurations cause this behavior? (Choose two)A . The packets fail to match any permit statementB ....
Which command enables a router to become a DHCP client?
Which command enables a router to become a DHCP client?A . ip address dhcpB . ip helper-addressC . ip dhcp poolD . ip dhcp clientView AnswerAnswer: A
How do traditional campus device management and Cisco DNA Center device management differ in regards to deployment?
How do traditional campus device management and Cisco DNA Center device management differ in regards to deployment?A . Cisco DNA Center device management can be implemented at a lower cost than most traditional campus device management optionsB . Traditional campus device management schemes can typically deploy patches and updates more...
Which design element is a best practice when deploying an 802.11b wireless infrastructure?
Which design element is a best practice when deploying an 802.11b wireless infrastructure?A . disabling TPC so that access points can negotiate signal levels with their attached wireless devices.B . setting the maximum data rate to 54 Mbps on the Cisco Wireless LAN ControllerC . allocating non overlapping channels to...
What are two descriptions of three-tier network topologies? (Choose two.)
What are two descriptions of three-tier network topologies? (Choose two.)A . The distribution layer runs Layer 2 and Layer 3 technologies.B . The network core is designed to maintain continuous connectivity when devices fail.C . The core layer maintains wired connections for each host.D . The core and distribution layers...
What are two benefits of network automation? (Choose two)
What are two benefits of network automation? (Choose two)A . reduced operational costsB . reduced hardware footprintC . faster changes with more reliable resultsD . fewer network failuresE . increased network securityView AnswerAnswer: AC
What is a difference between local AP mode and FlexConnect AP mode?
What is a difference between local AP mode and FlexConnect AP mode?A . FlexConnect AP mode fails to function if the AP loses connectivity with the WLC . FlexConnect AP mode bridges the traffic from the AP to the WLC when local switching is configured.D . Local AP mode creates...
Which two outcomes are predictable behaviors for HSRP? (Choose two)
Which two outcomes are predictable behaviors for HSRP? (Choose two)A . The two routers share a virtual IP address that is used as the default gateway for devices on the LAC . The two routers negotiate one router as the active router and the other as the standby routerD ....
