NS0-184

You are planning to update your running switch environment. You need to determine if certain conditions exist before the FASTPATH software and reference configuration file (RCF) on a NetApp CN16xx cluster switch can be installed. Which condition must exist in this scenario?A . You must set the port configuration to...

You configured AutoSupport and are trying to send a full AutoSupport message to NetApp. You use the autosupport history show command and see the output shown in the exhibit. The customer confirms that the AutoSupport settings are correct. Which two actions will solve this issue? (Choose two.)A . The customer...

You are performing HA failover tests on a 2-node cluster with FAS8200 controllers. You want to observe the boot process for the storage node in takeover. To which interface should you connect to accomplish this task?A . Service ProcessorB . SVM managementC . cluster managementD . node managementView AnswerAnswer: A

What is the purpose of a mailbox disk?A . for shipping defective drives back to NetAppB . for storing HA partner informationC . for loggingD . for sending AutoSupport mailView AnswerAnswer: B

Multiple customers want to access a cluster from different domains that may contain duplicate IP addresses. In this situation, which feature should you use?A . IPspacesB . interface groupsC . VLAND . logical interfacesView AnswerAnswer: A

You want to add additional nodes to a cluster. Which action will complete this task?A . Run the node join command on the new nodes.B . Run the cluster setup command on the new nodes.C . Run the cluster join command on the existing cluster.D . Run the cluster setup...

You completed the installation of an AFF A700s with NetApp CN1610 switches. You used ports e0a and e0f with breakout cables to connect the controllers to the interconnect switches. After completing the cluster setup, ports e0e and e0i are not visible in OnCommand System Manager. In this scenario, what caused...

After the Installation of a new 2-node cluster, you want to make sure that AutoSupport is working as expected from the cluster. In this scenario, what are two ways to trigger a new AutoSupport? (Choose two.)A . Use the ping command on the mailhost.B . Use the OnCommand Unified Manager...

While troubleshooting an issue with a newly installed system, you used the system controller environment show command. In this scenario, which issue would be diagnosed with this command?A . controller configuration issuesB . controller hardware issuesC . shelf cabling issuesD . controller version issuesView AnswerAnswer: B

You are adding new nodes to a 2-node switchless cluster. According to NetApp, what must you do before adding the nodes?A . You must configure cluster peering.B . must install interconnect switches.C . You must configure vserver peering.D . You must enable a cluster HAView AnswerAnswer: B