- All Exams Instant Download
Which three commands are required to enable NTP authentication on a Cisco router? (Choose three)
Which three commands are required to enable NTP authentication on a Cisco router? (Choose three)A . ntp peerB . ntp max-associationsC . ntp authenticateD . ntp trusted-keyE . ntp authentication-keyF . ntp refclockView AnswerAnswer: CDE
Refer to the command below. When configuring an SVS connection on the Cisco Nexus 5000 Series Switch, which device is being referenced as the remote IP address?
Refer to the command below. When configuring an SVS connection on the Cisco Nexus 5000 Series Switch, which device is being referenced as the remote IP address? nexus5500-2(config-svs-conn)# remote ip address 10.10.1.15 port 80 vrf managementA . ESX or ESXi hostB . vCenterC . vPC peer switchD . Cisco IMC...
NAPT is through TCP or UDP or IP packets in the protocol number to distinguish the different user's IP address.
NAPT is through TCP or UDP or IP packets in the protocol number to distinguish the different user's IP address.A . TrueB . FalseView AnswerAnswer: B
A VoIP line will MOST likely have which of the following connectors?
A VoIP line will MOST likely have which of the following connectors?A . RJ-11B . DB-25C . BNCD . RJ-45View AnswerAnswer: D
Which of the following is being used?
A technician has installed new vulnerability scanner software on a server that is joined to the company domain. The vulnerability scanner is able to provide visibility over the patch posture of all company's clients. Which of the following is being used?A . Gray box vulnerability testingB . Passive scanC ....
Which action will remedy this problem?
An administrator has enabled vSphere Distributed Switch Health Check. The hosts connected to that Distributed Switch all display an alert: vSphere Distributed Switch MTU supported status The administrator has all of the VMkernel ports MTU sizes set to 1600. Which action will remedy this problem?A . Configure the Distributed Switch...
Parameter which used to check the integrity of the received frame in 802.11 frame is() 。
Parameter which used to check the integrity of the received frame in 802.11 frame is() 。A . Frame ControlB . DurationC . FCSD . Sequence control bitView AnswerAnswer: C
Which two statements are true of the interfaces on switch1?
Refer to the exhibit. Which two statements are true of the interfaces on switch1? (choose two)A . A hub is connected directly to FastEthernet0/5B . FastEthernet0/1 is configured as a trunk link.C . FastEthernet0/5 has statically assigned mac addressD . Interface FastEthernet0/2 has been disable.E . Multiple devices are connected...
What are two possible ways to achieve this goal?
You administer a DirSync server configured with Azure Active Directory (Azure AD). You need to provision a user in Azure AD without waiting for the default DirSync synchronization interval. What are two possible ways to achieve this goal? Each correct answer presents a complete solution.A . Restart the DirSync server.B...
Which escape sequence must you use to enter special characters as part of a key string?
Which escape sequence must you use to enter special characters as part of a key string?A . CTRL+SB . CTRL+PC . CTRL+KD . CTRL+VView AnswerAnswer: D
