You have explicitly added the line deny ipv6 any log to the end of an IPv6 ACL on a router interface. Which two ICMPv6 packet types must you explicitly allow to enable traffic to traverse the interface? (Choose two.)

You have explicitly added the line deny ipv6 any log to the end of an IPv6 ACL on a router interface. Which two ICMPv6 packet types must you explicitly allow to enable traffic to traverse the interface? (Choose two.)A . router solicitationB . router advertisementC . neighbor solicitationD . neighbor...

June 17, 2018 No Comments READ MORE +

IGMP Snooping operates at the data link layer to manage and control multicast groups and solves the problem of multicast messages broadcast at Layer 3.

IGMP Snooping operates at the data link layer to manage and control multicast groups and solves the problem of multicast messages broadcast at Layer 3.A . TrueB . FalseView AnswerAnswer: B

June 17, 2018 No Comments READ MORE +

Which way is recommended to prevent these calls?

Your customer reports that they have had unwanted calls routing from their Cisco VCS Expressway to their ISDN gateway. Which way is recommended to prevent these calls?A . Configure a Registration Deny List on the Cisco VCS Expressway.B . Configure a Registration Allow List on the Cisco VCS Expressway.C ....

June 17, 2018 No Comments READ MORE +

Which are three basic elements of Cisco Performance Monitor? (Choose three)

Which are three basic elements of Cisco Performance Monitor? (Choose three)A . Master controllerB . SLAC . Flow recordD . Border routerE . PolicyF . ClassView AnswerAnswer: C E F

June 17, 2018 No Comments READ MORE +

What would be the best way to do this?

Amazon S3 allows you to set per-file permissions to grant read and/or write access. However you have decided that you want an entire bucket with 100 files already in it to be accessible to the public. You don't want to go through 100 files individually and set permissions. What would be the...

June 17, 2018 No Comments READ MORE +

In this scenario, why is this amount of space being used?

A customer has a 2TB volume. The volume guarantee is set to volume, the fractional reserve is set to 0, no snapshots copies exist, and a 500GB LUN shows 50% deduplication savings in the volume. The df command shows that 500GB are used. In this scenario, why is this amount...

June 17, 2018 No Comments READ MORE +

Which server-side state management option should you use?

You are designing a distributed application. The application must store a small amount of insecure global information that does not change frequently. You need to configure the application to meet the requirements. Which server-side state management option should you use? (Each correct answer presents a complete solution. Choose all that...

June 17, 2018 No Comments READ MORE +

A question related to a MAC address output. (Choose two.)

A question related to a MAC address output. (Choose two.) A . Fa0/1 and Fa0/2 are in the same VLAC . Fa0/1 and Fa0/2 are not in the same VLAE . Fa0/1 and Fa0/3 can not communicate on the Layer 2 switch.F . Fa0/3 and Fa0/2 can communicate on the...

June 17, 2018 No Comments READ MORE +

Which statement about EAP chaining is ture?

Which statement about EAP chaining is ture?A . It performs authentication on a device-only basisB . It requires EAP-FAST authenticationC . It supports RADIUS and TACACS+ authenticationD . It locks a unique certificate to BYOD devices to differentiate them from corporate-owned devicesE . It can be deployed in an agentless...

June 17, 2018 No Comments READ MORE +

If router R1 is configured to run IS-IS with given configuration and all interfaces are up/up, what action must you take so that the Ethernet 0/0 netwrok can be advertised to potential IS-IS neighbors on the E0/1 interface?

Refer to the exhibit. If router R1 is configured to run IS-IS with given configuration and all interfaces are up/up, what action must you take so that the Ethernet 0/0 netwrok can be advertised to potential IS-IS neighbors on the E0/1 interface?A . Configure the ip router isis command on...

June 17, 2018 No Comments READ MORE +