What will reduce Type 7 LSAs advertised from R2 to the non-backbone routers shown in the exhibit?

Exhibit: A network administrator is concerned about the number of LSAs that they are observing on the network. What will reduce Type 7 LSAs advertised from R2 to the non-backbone routers shown in the exhibit?A . Configure no-summaries under protocols ospf3 on R2.B . Configure no-naaa-abr under protocols ospf3 on...

January 5, 2021 No Comments READ MORE +

Referring to the exhibit, which path would traffic passing through R1 take to get

Exhibit: Referring to the exhibit, which path would traffic passing through R1 take to get.A . R1 -> R2 -> R4 -> R6B . R1 -> R2 -> R3 -> R6C . R1 -> R3 -> R5 -> R6D . R1 -> R3 -> R4 -> R6View AnswerAnswer: C

January 3, 2021 No Comments READ MORE +

What information is stored in a VRF table for a BGP Layer 2 VPN? (Choose three.)

What information is stored in a VRF table for a BGP Layer 2 VPN? (Choose three.)A . remote interface of local CE deviceB . Layer 2 encapsulationC . logical interface provisioned to local CE device local site IDD . label-switched pathView AnswerAnswer: B,C,D

January 3, 2021 No Comments READ MORE +

In this scenario where would you configure loop prevention?

Exhibit. You have the LDP signaled VPLS topology as shown in the exhibit CE-B at Site-2 is multihomed to both PE-2 and PE-3 In this scenario where would you configure loop prevention?A . PE-2B . PE-3C . CE-BD . PE-1View AnswerAnswer: D

January 2, 2021 No Comments READ MORE +

Referring to the exhibit, which two statements are true?

Exhibit: Referring to the exhibit, which two statements are true? (Choose two.)A . This router is an ABRB . This router is an ASBD . There are two interfaces marked as passive.E . There is one interface marked as passive.View AnswerAnswer: B,C

January 2, 2021 No Comments READ MORE +

What are two reasons for this behavior?

Exhibit: You notice an inconsistency between the routing table and the OSPF database, as shown in the exhibit. What are two reasons for this behavior? (Choose two.) A. The LSA is a Type 4 LSA. B. An OSPF export policy is being applied to the route. C. An OSPF import...

January 2, 2021 No Comments READ MORE +

In this scenario which two types of routing instances should be configured?

You are deploying a new EVPN service for your customers. You must build the service based on the following requirements -- both Layer 2 and Layer 3 functionality must be supported -- your customers must be able to support multiple VLANs in the same EVPN instance (EVI). In this scenario...

January 1, 2021 No Comments READ MORE +

Which three statements are true about the show pim join output shown in the exhibit?

Exhibit: Which three statements are true about the show pim join output shown in the exhibit? (Choose three.)A . This is a source-specific multicast stream. G The multicast receiver is still using the RP to receive the stream.B . The multicast stream does not have an RD . The multicast...

December 31, 2020 No Comments READ MORE +

Referring to the exhibit, which two statements are correct*?

Exhibit. You are troubleshooting a problem with a BGP peer where BGP routes are not being accepted from that peer. Referring to the exhibit, which two statements are correct*? (Choose two)A . Term 0 is missing a terminating action that allows BGP routes to be acceptedB . You cannot have...

December 30, 2020 No Comments READ MORE +

Referring to the exhibit, which statement is true?

Exhibit. You are provisioning Layer 2 circuits between sites CE1. CE2. andCE3 Referring to the exhibit, which statement is true?A . Two VLANs must be configured from PE1 to CE1.B . A point-to-multipoint LSP must be created between sites.C . Site PE1 must have a point-to-multipoint link configured towards the...

December 30, 2020 No Comments READ MORE +