In a Virtual Chassis configuration, which of the following is true?

In a Virtual Chassis configuration, which of the following is true?A . It allows physical stacking of switches that are geographically dispersed.B . It reduces the operational complexity of managing multiple switches.C . It decreases network redundancy and reliability.D . Only two switches can be connected in a Virtual Chassis...

May 18, 2025 No Comments READ MORE +

Which of the following are correct about OSPF router ID selection? (Choose two)

Which of the following are correct about OSPF router ID selection? (Choose two)A . It can be manually configured.B . It is chosen based on the highest IP address of any active interface by default.C . It is always the IP address of the loopback interface.D . It is selected...

May 17, 2025 No Comments READ MORE +

What is the default route preference for a static route on a Junos device?

What is the default route preference for a static route on a Junos device?A . 130B . 15C . 10D . 5View AnswerAnswer: D

May 16, 2025 No Comments READ MORE +

In the context of Ethernet bridging on Junos devices, what is the purpose of the Spanning Tree Protocol (STP)?

In the context of Ethernet bridging on Junos devices, what is the purpose of the Spanning Tree Protocol (STP)?A . To prevent routing loops.B . To provide a mechanism for VLAN tagging.C . To prevent Layer 2 switching loops.D . To filter MAC addresses.View AnswerAnswer: C

May 16, 2025 No Comments READ MORE +

What does the “qualified-next-hop” feature do when configuring a static route?

What does the “qualified-next-hop” feature do when configuring a static route?A . It allows you to specify an independent route preference value for an additional next hop.B . It specifies the IP address of the directly connected device.C . It instructs the device to verify the next-hop is reachable before...

May 13, 2025 No Comments READ MORE +

What is the purpose of using route reflectors in BGP?

What is the purpose of using route reflectors in BGP?A . To encrypt BGP messagesB . To reduce the number of required IBGP sessions in a networkC . To increase the speed of BGP convergenceD . To automatically select the best routeView AnswerAnswer: B

May 9, 2025 No Comments READ MORE +

Which two statements describe an OSPF ABR? (Choose two.)

Which two statements describe an OSPF ABR? (Choose two.)A . By default, an ABR does not need to have any links in the backbone area.B . By default, an ABR is an OSPF router with links in two areas.C . By default, an ABR is an OSPF router with all...

May 8, 2025 No Comments READ MORE +

In OSPF, which command is commonly used to monitor neighbor relationships?

In OSPF, which command is commonly used to monitor neighbor relationships?A . show ip ospf neighborsB . show ospf databaseC . show ip route ospfD . show ospf interfacesView AnswerAnswer: A

May 8, 2025 No Comments READ MORE +

What is a VLAN?

What is a VLAN?A . A local network using only virtual machinesB . A broadcast domain, identified by a VLAN IDC . A multicast domain, identified by a VLAN IDD . A broadcast domain, using only virtual machinesView AnswerAnswer: B

May 5, 2025 No Comments READ MORE +

What is an advantage of using BFD?

What is an advantage of using BFD?A . BFD is so lightweight that each protocol will generate its own unique BFD session by default, to replace its own hello messages.B . BFD built to handle the routing table of the entire Internet, and can safely redistribute it into OSPF.C ....

May 2, 2025 No Comments READ MORE +