Which of the following adjustment measures has the highest priority?

Which of the following adjustment measures has the highest priority?A . Antenna heightB . Antenna direction angle antenna downtilt angleC . Antenna typeView AnswerAnswer: C

October 4, 2018 No Comments READ MORE +

When the road test is performed using Huawei Probe, the downlink RSRP is observed to be good, but the number of uplink and downlink scheduling of the PDCCH is very small, which can be directly determined as network congestion.

When the road test is performed using Huawei Probe, the downlink RSRP is observed to be good, but the number of uplink and downlink scheduling of the PDCCH is very small, which can be directly determined as network congestion.A . TrueB . FalseView AnswerAnswer: B

October 2, 2018 No Comments READ MORE +

The modulo three principle in PCI planning is to make the remainder of the adjacent cell PCI modulo three as far as possible the same.

The modulo three principle in PCI planning is to make the remainder of the adjacent cell PCI modulo three as far as possible the same.A . TrueB . FalseView AnswerAnswer: B

September 30, 2018 No Comments READ MORE +

In the downlink scheduling, which factors will affect the allocation of downlink shared resources and the selection of MCS? (Multiple Choice)

In the downlink scheduling, which factors will affect the allocation of downlink shared resources and the selection of MCS? (Multiple Choice)A . UE capability levelB . The wireless environment where the user is locatedC . Cache statusD . PHR (power headroom report) of UEView AnswerAnswer: AB

September 24, 2018 No Comments READ MORE +

Regarding TA planning, which of the following statements is incorrect?

Regarding TA planning, which of the following statements is incorrect?A . The TA plan of LTE should be consistent with the LA plan of 2G/3C . Currently TAL of LTE can contain up to 16 TAsD . The number of cells in the TA of LTE should be smaller than...

September 8, 2018 No Comments READ MORE +

Assuming other conditions are unchanged, if the power parameter PB is changed from 0 to 1, then which of the following statements is correct?

Assuming other conditions are unchanged, if the power parameter PB is changed from 0 to 1, then which of the following statements is correct?A . Cell reference signal power is increased by 3dC . Cell reference signal power is increased by 1dBD . Cell reference signal power is reduced by...

September 7, 2018 No Comments READ MORE +

During the test, the bit error rate below 20% is normal.

During the test, the bit error rate below 20% is normal.A . TrueB . FalseView AnswerAnswer: B

August 27, 2018 No Comments READ MORE +

Which of the following statements about LTE tools is correct? (Multiple Choice)

Which of the following statements about LTE tools is correct? (Multiple Choice)A . Probe can be used for road test and playbackB . OMStar can be used for network verificationC . M2000 can be used to configure the network and check the message system.D . PRS can be used for...

August 24, 2018 No Comments READ MORE +