- All Exams Instant Download
Your Aruba CX 6300 VSF stack has OSPF adjacency over SVI 10 with LAG 1 to a neighboring device.
Your Aruba CX 6300 VSF stack has OSPF adjacency over SVI 10 with LAG 1 to a neighboring device. The following configuration was created on the switch: A) B) C) D) A . Option A B. Option B C. Option C D. Option DView AnswerAnswer: C Explanation: The correct configuration...
Which Aruba AP mode is sending captured RF data to Aruba Central for waterfall plot?
Which Aruba AP mode is sending captured RF data to Aruba Central for waterfall plot?A . Hybrid Mode B. Air Monitor C. Spectrum Monitor D. Dual ModeView AnswerAnswer: C Explanation: Spectrum Monitor is an Aruba AP mode that is sending captured RF data to Aruba Central for waterfall plot. Spectrum...
Which action must the administrator perform to address this situation?
A company deployed Dynamic Segmentation with their CX switches and Gateways After performing a security audit on their network, they discovered that the tunnels built between the CX switch and the Aruba Gateway are not encrypted. The company is concerned that bad actors could try to insert spoofed messages on...
Describe the difference between Class of Service (CoS) and Differentiated Services Code Point (DSCP).
Describe the difference between Class of Service (CoS) and Differentiated Services Code Point (DSCP).A . CoS is only used to determine CLASS of traffic DSCP is only used to differentiate between different Classes. B. CoS is only contained in VLAN Tag fields DSCP is in the IP Header and preserved...
Which method is used to onboard a new UXI in an existing environment with 802 1X authentication? (The sensor has no cellular connection)
Which method is used to onboard a new UXI in an existing environment with 802 1X authentication? (The sensor has no cellular connection) A. Use the UXI app on your smartphone and connect the UXI via Bluetooth B. Use the Aruba installer app on your smartphone to scan the barcode...
Which steps need to be implemented to allow ClearPass to perform a CoA and change the access for this wired device?
A network engineer recently identified that a wired device connected to a CX Switch is misbehaving on the network To address this issue, a new ClearPass policy has been put in place to prevent this device from connecting to the network again. Which steps need to be implemented to allow...
