- All Exams Instant Download
How will the reload of these switches proceed to result in the default initial state?
Two (2) Dell EMC Networking OS10 switches in a VLT configuration need to be upgraded. How will the reload of these switches proceed to result in the default initial state?A . Reload the primary VLT node. This process will automatically trigger the reload of the secondary node after it has...
Which best describes traffic flow in a campus network environment?
Which best describes traffic flow in a campus network environment?A . North-EastB . South-WestC . East-WestD . North-SouthView AnswerAnswer: C
Which command mode allows configuration of switches L2 and L3 interfaces?
Which command mode allows configuration of switches L2 and L3 interfaces?A . EXEC ModeB . InterfaceC . ConfigurationD . GlobalView AnswerAnswer: B
When installing OS10 on a switch from a USB drive, what format is used for the file system?
When installing OS10 on a switch from a USB drive, what format is used for the file system?A . HFS+B . FAT32C . NTFSD . HFSView AnswerAnswer: B
What type of network in a Data Center flattens the core and aggregation layers into a single tier?
What type of network in a Data Center flattens the core and aggregation layers into a single tier?A . LeafB . Leaf-spineC . SpineD . TRILLView AnswerAnswer: B
Which three commands are used when deploying an automated Leaf and Spine topology using SFS?
Refer to the exhibit. Which three commands are used when deploying an automated Leaf and Spine topology using SFS? (Select 3)A . Leaf1(conf)# smartfabric l3fabric enable role LEAF vlti ethernet 1/1/10B . Spine1(conf)# smartfabric l3fabric enable role SPINE preferC . Spine1(conf)# smartfabric l3fabric enable role SPINE downstream ethernet 1/1/1-1/1/2D ....
In a PIM Sparse Mode (PIM-SM) based multicast topology, what function does the Rendezvous Point provide?
In a PIM Sparse Mode (PIM-SM) based multicast topology, what function does the Rendezvous Point provide?A . The node is used to provide IGMP snooping across a layer 3 boundary.B . The root node of the source tree topology is used to provide routing between the source and receiver.C ....
What is the maximum number of LLDP neighbors supported per system with OS10?
What is the maximum number of LLDP neighbors supported per system with OS10?A . 250B . 256C . 384D . 512View AnswerAnswer: A
Which configuration will allow S1 to ping S2’s Lo0 address?
Refer to the exhibit. Which configuration will allow S1 to ping S2’s Lo0 address?A . S1(config-router)# ip route 144.254.32.1 192.168.32.2/32B . S1(config-router)# ip route 192.168.32.2 144.254.32.1/32C . S1(config)# ip route 144.254.32.1/32 192.168.32.2D . S1(config)# ip route 192.168.32.2 144.254.32.1/32View AnswerAnswer: C
What do bridge protocol data units provide?
What do bridge protocol data units provide?A . Special data frames to exchange STP informationB . Metadata transferred connecting two network bridgesC . Configuration data exchanged during a VLTi setupD . Bridge information part of the LLDP protocolView AnswerAnswer: A
