Exam4Training

CWNP CWT-100 Certified Wireless Technician Online Training

Question #1

In what way are 802.11 channels defined?

  • A . By a high frequency and channel width
  • B . By channel width alone
  • C . By a center frequency and channel width
  • D . By a low frequency and channel width

Reveal Solution Hide Solution

Correct Answer: B
Question #2

What can occur when two copies of a signal wave arrive at the receiver at the same time, but 180 degrees out of phase which each other?

  • A . Increased signal amplitude
  • B . Bits may be added to the total count
  • C . Increased signal strength
  • D . Signal nulling or cancellation

Reveal Solution Hide Solution

Correct Answer: D
Question #3

What is defined as the bending of an RF wave as it passes through a medium?

Select one:

  • A . Reflection
  • B . Refraction
  • C . Absorption
  • D . Scattering

Reveal Solution Hide Solution

Correct Answer: B
Question #4

What metric is most commonly used at the receiver to report the signal strength?

Select one:

  • A . dBm
  • B . Watt
  • C . Milliwatt
  • D . Nanowatt

Reveal Solution Hide Solution

Correct Answer: A
Question #5

At what point is RF power typically stipulated in milliwatts?

  • A . At the transmitter
  • B . Fifty feet from the transmitter
  • C . At the receiver
  • D . One hundred feet from the transmitter

Reveal Solution Hide Solution

Correct Answer: A
Question #6

How many channels are available in the 2.4 GHz frequency band in all regulatory domains?

Select one:

  • A . 3
  • B . 14
  • C . 13
  • D . 11

Reveal Solution Hide Solution

Correct Answer: B
Question #7

How many non-overlapping channels are available in regulatory domains in the 2.4 GHz frequency band?

Select one:

  • A . 14
  • B . 1
  • C . 3
  • D . 11

Reveal Solution Hide Solution

Correct Answer: C
Question #8

What antenna would be best for a long distance (more than 5 kilometers) bridge link?

Select one:

  • A . Panel
  • B . Parabolic dish
  • C . Patch
  • D . Omnidirectional

Reveal Solution Hide Solution

Correct Answer: B
Question #9

What kind of antenna chart shows the radiation pattern of an antenna from the side view of that antenna?

  • A . Top-down
  • B . Azimuth
  • C . Horizontal
  • D . Elevation

Reveal Solution Hide Solution

Correct Answer: B
Question #10

In what kind of device is a mini-PCIe 802.11 adapter most likely to be used?

  • A . Desktop
  • B . Mobile phone
  • C . Laptop
  • D . USB adapter

Reveal Solution Hide Solution

Correct Answer: C

Question #11

Of the following device types, which one is most likely to be used in a highly mobile (use while in motion) use case?

  • A . Desktop
  • B . Video camera
  • C . VoIP handset
  • D . Laptop

Reveal Solution Hide Solution

Correct Answer: D
Question #12

What is a common problem in specialty Wi-Fi devices?

  • A . The use of 802.11 VHT-only chipsets
  • B . The use of older, less capable 802.11 chipsets
  • C . The use of 802.11 DSSS-only chipsets
  • D . The use of newer, more capable 802.11 chipsets

Reveal Solution Hide Solution

Correct Answer: B
Question #13

What best describes passive scanning used to locate WLANs?

  • A . Sending probe requests and listening for probe responses
  • B . Scanning in only on frequency band
  • C . Listening for beacon frames from the APs
  • D . Scanning on only one channel

Reveal Solution Hide Solution

Correct Answer: C
Question #14

What device type is configured to respond when a probe request is received in a BSS?

  • A . Desktop
  • B . Switch
  • C . Laptop
  • D . AP

Reveal Solution Hide Solution

Correct Answer: D
Question #15

What process is used after authentication to generate and install encryption keys on 802.11 devices using WPA2?

  • A . 802.1X port-based authentication
  • B . Passphrase to PSK mapping algorithm
  • C . EAP authentication
  • D . 4-way handshake

Reveal Solution Hide Solution

Correct Answer: D
Question #16

What kind of authentication is used by WPA2-Enterprise implementations?

Select one:

  • A . WEP
  • B . Preshared key
  • C . 802.1X/EAP
  • D . Passphrase

Reveal Solution Hide Solution

Correct Answer: C
Question #17

What 802.11 process must always occur before 802.11 association?

  • A . Time synchronization
  • B . Authentication
  • C . Confidentiality
  • D . Encryption

Reveal Solution Hide Solution

Correct Answer: B
Question #18

A device is a 3×2:2 device.

How many spatial streams can it receive?

  • A . 3
  • B . 9
  • C . 6
  • D . 2

Reveal Solution Hide Solution

Correct Answer: D
Question #19

How many non-overlapping 20 MHz channels are available in the 5 GHz frequency band assuming the

regulatory domain allows them all?

  • A . 11
  • B . 25
  • C . 24
  • D . 14

Reveal Solution Hide Solution

Correct Answer: C
Question #20

What is the maximum channel width supported by 802.11ac (VHT) in the standard?

  • A . 40 MHz
  • B . 80 MHz
  • C . 160 MHz
  • D . 20 MHz

Reveal Solution Hide Solution

Correct Answer: C

Question #21

What is the maximum channel width recommended in the 2.4 GHz frequency band for 802.11n devices?

  • A . 80 MHz
  • B . 20 MHz
  • C . 40 MHz
  • D . 10 MHz

Reveal Solution Hide Solution

Correct Answer: B
Question #22

What can be configured in some client devices to encourage them to use 5 GHz APs whenever they are available?

  • A . Band preference
  • B . Gaming mode
  • C . Band selection
  • D . Roaming aggressiveness

Reveal Solution Hide Solution

Correct Answer: A
Question #23

What Windows Command Prompt command may be used to configure wireless settings on Windows

computers?

  • A . TRACERT
  • B . PING
  • C . NETSH
  • D . IPCONFIG

Reveal Solution Hide Solution

Correct Answer: C
Question #24

What EAP method is supported on most operating systems without additional installation requirements?

  • A . EAP-GTC
  • B . EAP-FAST
  • C . EAP-TLS
  • D . LEAP

Reveal Solution Hide Solution

Correct Answer: B
Exit mobile version