350-601

Which two settings must be configured before enabling a Cisco UCS Manager domain for Cisco Intersight connectivity? (Choose two.)A . SMTP serversB . SMTP reply-to addressC . NTP serversD . syslog redirectionE . DNS serversView AnswerAnswer: CE

An engineer is seeking the most optimal on demand CPU performance while configuring the BIOS settings of a UCS C-series rack mount server. What setting will accomplish this goal?A . C6 RetentionB . C6 non-RetentionC . C2 stateD . C0/C1 stateView AnswerAnswer: A

Refer to the exhibit. What must be connected to clear the HA NOT READY status?A . Layer 1-Layer 2 portsB . server chassisC . management portsD . network uplinksView AnswerAnswer: B

An engineer is duplicating an existing Cisco UCS setup at a new site. What are two characteristics of a logical configuration backup of a Cisco UCS Manager database? (Choose two.)A . contains the configured organizations and localesB . contains the VLAN and VSAN configurationsC . contains the AAA and RBAC...

Host1 is in VLAN100 located in DataCenter1 and Host2 is in VLAN200 located in DataCenter2. Which OTV VLAN mapping configuration allows Layer 2 connectivity between these two hosts? A) B) C) D) A . Option AB . Option BC . Option CD . Option DView AnswerAnswer: A

What happens to the default host firmware policy after a Cisco UCS Manager upgrade?A . It is assigned to all the service profiles that include a host firmware policy.B . It is replaced by a new default policy without any firmware entries.C . It is set to match the host...

Which configuration implements static ingress replication? A) B) C) D) A . Option AB . Option BC . Option CD . Option DView AnswerAnswer: D

A small remote office is set to connect to the regional hub site via NSSA ASBR. Which type of LSA is sent to the remote office OSPF area?A . type 7 LSAB . type 1 LSAC . type 5 LSAD . type 3 LSAView AnswerAnswer: A

Which mroute state is created when Bidirectional PIM is deployed at a site?A . *.GB . MVPN Type-6C . MVPN Type-7E . GView AnswerAnswer: A

Refer to the exhibit. A flapping link issue has been reported on the vPC keepalive link. A packet capture has been activated on the Cisco Nexus switch. What is the destination IP address of the vPC keepalive packets that are sent by the switch?A . 192.168.254.4B . 192.168.254.1C . 192.168.254.2D...