- All Exams Instant Download
Which command set must be configured on switch1 to achieve the following results on port fa0/1?
Refer to the Exhibit. Rapid PVST+ is enabled on all switches. Which command set must be configured on switch1 to achieve the following results on port fa0/1? ✑ When a device is connected, the port transitions immediately to a forwarding state. ✑ The interface should not send or receive BPDUs....
What is the data policy in a Cisco SD-WAN deployment?
What is the data policy in a Cisco SD-WAN deployment?A . list of ordered statements that define node configurations and authentication used within the SD-WAN overlayB . Set of statements that defines how data is forwarded based on IP packet information and specific VPNsC . detailed database mapping several kinds...
What is used to perform OoS packet classification?
What is used to perform OoS packet classification?A . the Options field in the Layer 3 headerB . the Type field in the Layer 2 frameC . the Flags field in the Layer 3 headerD . the TOS field in the Layer 3 headerView AnswerAnswer: D Explanation: Type of service,...
Which command ensures that SW3 receives frames only from VLAN 50?
Refer to exhibit. VLANs 50 and 60 exist on the trunk links between all switches All access ports on SW3 are configured for VLAN 50 and SW1 is the VTP server. Which command ensures that SW3 receives frames only from VLAN 50?A . SW1 (config)#vtp pruningB . SW3(config)#vtp mode transparentC...
