- All Exams Instant Download
What does the error message relay to the administrator who is trying to configure a Cisco IOS device?
Refer to the exhibit. What does the error message relay to the administrator who is trying to configure a Cisco IOS device?A . A NETCONF request was made for a data model that does not exist. B. The device received a valid NETCONF request and serviced it without error. C....
If the noise floor is -90 dBm and wireless client is receiving a signal of -75 dBm, what is the SNR?
If the noise floor is -90 dBm and wireless client is receiving a signal of -75 dBm, what is the SNR?A . 15 B. 1.2 C. -165 D. .83View AnswerAnswer: A
Which design facilities a migrate from a traditional campus design to a programmer fabric designer?
A company plans to implement intent-based networking in its campus infrastructure. Which design facilities a migrate from a traditional campus design to a programmer fabric designer?A . Layer 2 access B. three-tier C. two-tier D. routed accessView AnswerAnswer: C
What does the snippet of code achieve?
Refer to the exhibit. What does the snippet of code achieve?A . It creates a temporary connection to a Cisco Nexus device and retrieves a token to be used for API calls. B. It opens a tunnel and encapsulates the login information, if the host key is correct. C. It...
In cisco SD_WAN, which protocol is used to measure link quality?
In cisco SD_WAN, which protocol is used to measure link quality?A . OMP B. BFD C. RSVP D. IPsecView AnswerAnswer: B Explanation: The BFD (Bidirectional Forwarding Detection) is a protocol that detects link failures as part of the Cisco SD-WAN (Viptela) high availability solution, is enabled by default on all...
Which two configuration allow peering session to from between R1 and R2?
A network engineer configures BGP between R1 and R2. Both routers use BGP peer group CORP and are set up to use MD5 authentication. This message is logged to the console of router R1: “ May 5 39:85:55.469: %TCP-6-BADAUTH ” Invalid MD5 digest from 10.10.10.1 (29832) to 10.120.10.1 (179) tebleid...
Drag and drop the characteristics from the left onto the orchestration tools they describe on the right
DRAG DROP Drag and drop the characteristics from the left onto the orchestration tools they describe on the right. View AnswerAnswer:
Refer to the exhibit.
Refer to the exhibit. An engineer must deny HTTP traffic from host A to host B while allowing all other communication between the hosts, drag and drop the commands into the configuration to achieve these results. Some commands may be used more than once. Not all commands are used. View...
Which virtual MAC address does the group use?
An engineer configures HSRP group 37. The configuration does not modify the default virtual MAC address. Which virtual MAC address does the group use?A . C0:00:00:25:00:00 B. 00:00:0c:07:ac:37 C. C0:39:83:25:258:5 D. 00:00:0c:07:ac:25View AnswerAnswer: D
Which JSON syntax is valid?
Which JSON syntax is valid?A . {“switch”:”name”:”dist1″,”interfaces”:[“gig1″,”gig2″,”gig3”]} B. {„switch‟:(„name‟:‟dist1′,‟interfaces‟:[„gig1′,‟gig2′,‟gig3‟])} C. {“switch”:{“name”:”dist1″,”interfaces”:[“gig1″,”gig2″,”gig3”]}} D. {/”switch/”:{/”name/”:”dist1″,/”interfaces/”:[“gig1″,”gig2″,”gig3”]}}View AnswerAnswer: C Explanation: This JSON can be written as follows: { 'switch': { 'name': 'dist1', 'interfaces': ['gig1', 'gig2', 'gig3'] } }
