- All Exams Instant Download
What is one fact about Cisco SD-Access wireless network deployments?
What is one fact about Cisco SD-Access wireless network deployments?A . The access point is part of the fabric underlay B. The WLC is part of the fabric underlay C. The access point is part the fabric overlay D. The wireless client is part of the fabric overlayView AnswerAnswer: C
Which action resolves the EtherChannel issue between SW2 and SW3?
Refer to the exhibit. Which action resolves the EtherChannel issue between SW2 and SW3?A . Configure switchport mode trunk on SW2. B. Configure switchport nonegotiate on SW3 C. Configure channel-group 1 mode desirable on both interfaces. D. Configure channel-group 1 mode active on both interfaces.View AnswerAnswer: D
Which HTTP JSON response does the python code output give?
Refer to the exhibit. Which HTTP JSON response does the python code output give?A . NameError: name 'json' is not defined B. KeyError 'kickstart_ver_str' C. 7.61 D. 7.0(3)I7(4)View AnswerAnswer: D
At which Layer does Cisco DNA Center support REST controls?
At which Layer does Cisco DNA Center support REST controls?A . EEM applets or scripts B. Session layer C. YMAL output from responses to API calls D. Northbound APIsView AnswerAnswer: D
Which action completes the configuration to achieve a dynamic continuous mapped NAT for all users?
Refer to the exhibit. Which action completes the configuration to achieve a dynamic continuous mapped NAT for all users?A . Configure a match-host type NAT pool B. Reconfigure the pool to use the 192.168 1 0 address range C. Increase the NAT pool size to support 254 usable addresses D....
How was spanning-tree configured on this interface?
Refer to the exhibit How was spanning-tree configured on this interface?A . By entering the command spanning-tree portfast trunk in the interface configuration mode. B. By entering the command spanning-tree portfast in the interface configuration mode C. By entering the command spanning-tree mst1 vlan 10,20,30,40 in the global configuration mode...
Which router is the designated router on the segment 192.168.0.0/24?
Refer the exhibit. Which router is the designated router on the segment 192.168.0.0/24?A . This segment has no designated router because it is a nonbroadcast network type. B. This segment has no designated router because it is a p2p network type. C. Router Chicago because it has a lower router...
What does the response indicate?
An engineer runs the code against an API of Cisco DMA Center, and the platform returns this output What does the response indicate?A . The authentication credentials are incorrect B. The URl string is incorrect. C. The Cisco DNA Center API port is incorrect D. The HTTP method is incorrectView...
Which measure is used by an NTP server to indicate its closeness to the authoritative time source?
Which measure is used by an NTP server to indicate its closeness to the authoritative time source?A . latency B. hop count C. time zone D. stratumView AnswerAnswer: D
Which explanation of this behavior is true?
Refer to the exhibit. An engineer must block all traffic from a router to its directly connected subnet 209.165.200.0/24. The engineer applies access control list EGRESS in the outbound direction on the GigabitEthernet0/0 interface of the router However, the router can still ping hosts on the 209.165.200.0/24 subnet. Which explanation...
