- All Exams Instant Download
Which LISP component is required for a LISP site to communicate with a non-LISP site?
Which LISP component is required for a LISP site to communicate with a non-LISP site?A . ETR B. ITR C. Proxy ETR D. Proxy ITRView AnswerAnswer: C
Which action resolves the EtherChannel issue between SW2 and SW3?
Refer to the exhibit. Which action resolves the EtherChannel issue between SW2 and SW3?A . Configure switchport mode trunk on SW2. B. Configure switchport nonegotiate on SW3 C. Configure channel-group 1 mode desirable on both interfaces. D. Configure channel-group 1 mode active on both interfaces.View AnswerAnswer: D
If the noise floor is -90 dBm and wireless client is receiving a signal of -75 dBm, what is the SNR?
If the noise floor is -90 dBm and wireless client is receiving a signal of -75 dBm, what is the SNR?A . 15 B. 1.2 C. -165 D. .83View AnswerAnswer: A
What does the error message relay to the administrator who is trying to configure a Cisco IOS device?
Refer to the exhibit. What does the error message relay to the administrator who is trying to configure a Cisco IOS device?A . A NETCONF request was made for a data model that does not exist. B. The device received a valid NETCONF request and serviced it without error. C....
When is an external antenna used inside a building?
When is an external antenna used inside a building?A . only when using Mobility Express B. when it provides the required coverage C. only when using 2 4 GHz D. only when using 5 GHzView AnswerAnswer: B
Which antenna type should the engineer use?
An engineer must provide wireless converge in a square office. The engineer has only one AP and believes that it should be placed it in the middle of the room. Which antenna type should the engineer use?A . directional B. polarized C. Yagi D. omnidirectionalView AnswerAnswer: D
Which two configuration allow peering session to from between R1 and R2?
A network engineer configures BGP between R1 and R2. Both routers use BGP peer group CORP and are set up to use MD5 authentication. This message is logged to the console of router R1: Which two configuration allow peering session to from between R1 and R2? Choose two.)A . R1(config-router)#neighbor...
Which action reduces the user impact?
Wireless users report frequent disconnections from the wireless network. While troubleshooting a network engineer finds that after the user a disconnect, the connection re-establishes automatically without any input required. The engineer also notices these message logs . Which action reduces the user impact?A . increase the AP heartbeat timeout B....
VLANs 50 and 60 exist on the trunk links between all switches All access ports on SW3 are configured for VLAN 50 and SW1 is the VTP server Which command ensures that SW3 receives frames only from VLAN 50?
Refer to exhibit. VLANs 50 and 60 exist on the trunk links between all switches All access ports on SW3 are configured for VLAN 50 and SW1 is the VTP server Which command ensures that SW3 receives frames only from VLAN 50?A . SW1 (config)#vtp pruning B. SW3(config)#vtp mode transparent...
Which command set must be configured on switch1 to achieve the following results on port fa0/1?
Refer to the exhibit. Rapid PVST+ is enabled on all switches. Which command set must be configured on switch1 to achieve the following results on port fa0/1? A) B) C) D) A . Option A B. Option B C. Option C D. Option DView AnswerAnswer: D
