- All Exams Instant Download
Which method of account authentication does OAuth 2.0 within REST APIs?
Which method of account authentication does OAuth 2.0 within REST APIs?A . username/role combination B. access tokens C. cookie authentication D. basic signature workflowView AnswerAnswer: B Explanation: The most common implementations of OAuth (OAuth 2.0) use one or both of these tokens: + access token: sent like an API key,...
Which two technologies allow every end host in a VLAN to use both gateways?
A network administrator has designed a network with two multilayer switches on the distribution layer, which act as default gateways for the end hosts. Which two technologies allow every end host in a VLAN to use both gateways? (Choose two)A . GLBP B. HSRP C. MHSRP D. VSS E. VRRPView...
Which devices does Cisco DNA Center configure when deploying an IP-based access control policy?
Which devices does Cisco DNA Center configure when deploying an IP-based access control policy?A . All devices integrating with ISE B. selected individual devices C. all devices in selected sites D. all wired devicesView AnswerAnswer: C Explanation: When you click Deploy, Cisco DNA Center requests the Cisco Identity Services Engine...
Which two configuration allow peering session to from between R1 and R2?
A network engineer configures BGP between R1 and R2. Both routers use BGP peer group CORP and are set up to use MD5 authentication. This message is logged to the console of router R1: “ May 5 39:85:55.469: %TCP-6-BADAUTH ” Invalid MD5 digest from 10.10.10.1 (29832) to 10.120.10.1 (179) tebleid...
Which is the cause of the message?
Refer to the exhibit. An engineer configures a new HSRP group. While reviewing the HSRP status, the engineer sees the logging message generated on R2. Which is the cause of the message?A . The same virtual IP address has been configured for two HSRP groups B. The HSRP configuration has...
What does the output verify?
A network engineer configures a new GRE tunnel and enters the show run command. What does the output verify?A . The tunnel will be established and work as expected B. The tunnel destination will be known via the tunnel interface C. The tunnel keepalive is configured incorrectly because they must...
SwitchC connects HR and Sales to the Core switch However, business needs require that no traffic from the Finance VLAN traverse this switch Which command meets this requirement?
Refer to the exhibit. SwitchC connects HR and Sales to the Core switch However, business needs require that no traffic from the Finance VLAN traverse this switch Which command meets this requirement?A . SwitchC(config)#vtp pruning B. SwitchC(config)#vtp pruning vlan 110 C. SwitchC(config)#interface port-channel 1 SwitchC(config-if)#switchport trunk allowed vlan add 210,310...
What does the output confirm?
Refer to the exhibit. An engineer configures monitoring on SW1 and enters the show command to verify operation. What does the output confirm?A . SPAN session 1 monitors activity on VLAN 50 of a remote switch B. SPAN session 2 only monitors egress traffic exiting port FastEthernet 0/14. C. SPAN...
What are two differences between the RIB and the FIB? (Choose two.)
What are two differences between the RIB and the FIB? (Choose two.)A . The FIB is derived from the data plane, and the RIB is derived from the FIB. B. The RIB is a database of routing prefixes, and the FIB is the Information used to choose the egress interface...
Which action completes the configuration to achieve a dynamic continuous mapped NAT for all users?
Refer to the exhibit. Which action completes the configuration to achieve a dynamic continuous mapped NAT for all users?A . Configure a match-host type NAT pool B. Reconfigure the pool to use the 192.168 1 0 address range C. Increase the NAT pool size to support 254 usable addresses D....
