- All Exams Instant Download
Which configuration commands can the engineer use to allow this traffic without disrupting existing traffic flows?
Refer to the exhibit. An engineer must modify the access control list EGRESS to allow all IP traffic from subnet 10.1.10.0/24 to 10.1.2.0/24. The access control list is applied in the outbound direction on router interface GigabitEthemet 0/1. Which configuration commands can the engineer use to allow this traffic without...
Which configuration change will force BR2 to reach 209 165 201 0/27 via BR1?
Refer to the Exhibit. Which configuration change will force BR2 to reach 209 165 201 0/27 via BR1?A . Set the weight attribute to 65.535 on BR1 toward PE1.B . Set the local preference to 150 on PE1 toward BR1 outboundC . Set the MED to 1 on PE2 toward...
What are two effects of this configuration?
Refer to the exhibit. What are two effects of this configuration? (Choose two.)A . R1 becomes the active router.B . R1 becomes the standby router.C . If R2 goes down, R1 becomes active but reverts to standby when R2 comes back online.D . If R1 goes down. R2 becomes active...
Which method can a client use to authenticate to the network?
Refer to the exhibit. Based on the configuration in this WLAN security setting. Which method can a client use to authenticate to the network?A . text stringB . username and passwordC . certificateD . RADIUS tokenView AnswerAnswer: A
When two actions from the initial value of the TTL?
Refer to the exhibit. Which troubleshooting a routing issue, an engineer issues a ping from S1 to S2. When two actions from the initial value of the TTL? (Choose two.)A . The packet reaches R3, and the TTL expiresB . R2 replies with a TTL exceeded messageC . R3 replies...
In a wireless Cisco SD-Access deployment, which roaming method is used when a user moves from one access point to another on a different access switch using a single WLC?
In a wireless Cisco SD-Access deployment, which roaming method is used when a user moves from one access point to another on a different access switch using a single WLC?A . Layer 3B . inter-xTRC . auto anchorD . fast roamView AnswerAnswer: B Explanation: A fabric edge node provides onboarding...
What does the output verify?
Refer to the Exhibit. A network engineer configures a new GRE tunnel and enters the show run command. What does the output verify?A . The tunnel will be established and work as expectedB . The tunnel destination will be known via the tunnel interfaceC . The tunnel keepalive is configured...
What does the output confirm?
Refer to the exhibit. An engineer configures monitoring on SW1 and enters the show command to verify operation. What does the output confirm?A . SPAN session 1 monitors activity on VLAN 50 of a remote switchB . SPAN session 2 only monitors egress traffic exiting port FastEthernet 0/14.C . SPAN...
What are two differences between the RIB and the FIB? (Choose two.)
What are two differences between the RIB and the FIB? (Choose two.)A . The FIB is derived from the data plane, and the RIB is derived from the FIB.B . The RIB is a database of routing prefixes, and the FIB is the Information used to choose the egress interface...
Which router is the designated router on the segment 192.168.0.0/24?
Refer the exhibit. Which router is the designated router on the segment 192.168.0.0/24?A . This segment has no designated router because it is a nonbroadcast network type.B . This segment has no designated router because it is a p2p network type.C . Router Chicago because it has a lower router...
