- All Exams Instant Download
What does the output confirm about the switch’s spanning tree configuration?
Refer to the exhibit. What does the output confirm about the switch’s spanning tree configuration?A . The spanning-tree mode stp ieee command was entered on this switchB . The spanning-tree operation mode for this switch is PVSTC . The spanning-tree operation mode for this switch is IEEED . The spanning-tree...
What is a benefit of deploying an on-premises infrastructure versus a cloud infrastructure deployment?
What is a benefit of deploying an on-premises infrastructure versus a cloud infrastructure deployment?A . faster deployment times because additional infrastructure does not need to be purchasedB . lower latency between systems that are physically located near each otherC . less power and cooling resources needed to run infrastructure on-premisesD...
Drag and drop the virtual component from the left onto their descriptions on the right.
Drag and drop the virtual component from the left onto their descriptions on the right. View AnswerAnswer:
What is provided by the Stealth watch component of the Cisco Cyber Threat Defense solution?
What is provided by the Stealth watch component of the Cisco Cyber Threat Defense solution?A . real-time threat management to stop DDoS attacks to the core and access networksB . real-time awareness of users, devices and traffic on the networkC . malware controlD . dynamic threat control for web trafficView...
Which data is properly formatted with JSON?
Which data is properly formatted with JSON? Option A Option B Option C Option D A . Option AB . Option BC . Option CD . Option DView AnswerAnswer: D
What is the result when a switch that is running PVST+ is added to this network?
Refer to the exhibit. What is the result when a switch that is running PVST+ is added to this network?A . Spanning tree is disabled automatically on the networkB . DSW2 operates in Rapid PVST+ and the new switch operates in PVST+C . Both switches operate in the PVST+ modeD...
Drag and drop characteristics of PIM dense mode from the left to the right.
Drag and drop characteristics of PIM dense mode from the left to the right. View AnswerAnswer:
Which two commands must be added to the existing configuration to accomplish this task?
Refer to the exhibit. An engineer must assign an IP address of 192.168.1.1/24 to the GigabitEthemet1 interface. Which two commands must be added to the existing configuration to accomplish this task? (Choose two)A . Router(config-vrf)#address-family ipv6B . Router(config-if)#ip address 192.168.1.1 255.255.255.0C . Router(config-vrf)#ip address 192.168.1.1 255.255.255.0D . Router(config-if)#address-family ipv4E ....
Which two components are supported by LISP? (Choose two)
Which two components are supported by LISP? (Choose two)A . proxy ETRB . HMAC algorithmC . route reflectorD . egress tunnel routerE . spokeView AnswerAnswer: A D
Which two commands ensure that traffic from PC1 is forwarded over Gi1/3 trunk port between DWS1 and DSW2?
Refer to the exhibit. All switches are configured with the default port priority value. Which two commands ensure that traffic from PC1 is forwarded over Gi1/3 trunk port between DWS1 and DSW2? (Choose two)A . DWS1(config-if)#spanning-tree port-priority 0B . DSW2(config-if)#spanning-tree port-priority 16C . DSW1(config-if)#interface gi1/3D . DSW2(config-if)#interface gi1/3E . DSW2(config-if)#spanning-tree...
