How should this be accomplished?

An administrator is asked to configure egress call routing by applying globalization and localization on Cisco UCM . How should this be accomplished?A . Localize the calling and called numbers to PSTN format and globalize the calling and called numbers in the gateway.B . Globalize the calling and called numbers...

October 28, 2021 No Comments READ MORE +

What is the cause of the failure?

An engineer has two cisco UCM Clusters and wants to integrate them using ILS with TLS certificates. Cluster A (pub and 1 subscriber) will be the hub, and Cluster B (pub and 1 subscriber) will be the spoke. Both Clusters have self-signed certificates. The engineer has exchanged Publisher A and...

October 28, 2021 No Comments READ MORE +

Which command does the engineer use to ensure that the call is reverted to the user after 60 seconds?

An engineer is configuring a call park feature in Cisco Unified Communications Manager Express . Which command does the engineer use to ensure that the call is reverted to the user after 60 seconds?A . R2(config-ephone-dn)#park reservation-group 60B . R2(config-ephone-dn)#park-slot timeout 60 limit 2 recall alternate 3002C . R2(config-ephone-dn)#park reservation-group...

October 27, 2021 No Comments READ MORE +

Which configuration should be added to the outgoing dial peer to resolve this issue?

When a third-party SIP Phone System is dialed inbound across a Cisco Unified Border Element, DTMF is failing. The third-party vendor accepts only out-of-band DTMF . Which configuration should be added to the outgoing dial peer to resolve this issue?A . dtmf-relay h245-signalB . dtmf-relay rtp-nteC . dtmf-relay cisco-rtpD ....

October 27, 2021 No Comments READ MORE +

As an administrator, what should be configured in the Cisco UCM to accomplish this?

A user requests a feature to send an active call to the mobile phone number on the physical phone. As an administrator, what should be configured in the Cisco UCM to accomplish this?A . A Remote Destination Profile having the same extension as the Mobile phone's number adds the physical...

October 27, 2021 No Comments READ MORE +

Which action is correct with respect to toll fraud prevention configuration in the Cisco Unified Communications Manager Express?

Which action is correct with respect to toll fraud prevention configuration in the Cisco Unified Communications Manager Express?A . Configure Direct Inward Dial for Incoming ISDN Calls with overlap dialing.B . Configure IP Address Trusted Authentication for Incoming VoIP Calls.C . Configure the command no ip address trusted authenticate under...

October 26, 2021 No Comments READ MORE +

Based on the configuration and SDP from the INVITE message, which codec is chosen by Cisco Unified Border Element for the inbound call leg?

Refer to the exhibit. The Cisco Unified Border Element receives an INVITE matching inbound dial peer 5002. The outbound dial peer supports only iLBC. and a Local Transcoding Interface is allocated. Based on the configuration and SDP from the INVITE message, which codec is chosen by Cisco Unified Border Element...

October 25, 2021 No Comments READ MORE +

What is the relationship between partition, time schedule, and time period in Time-of-Day routing in Cisco Unified Communications Manager?

What is the relationship between partition, time schedule, and time period in Time-of-Day routing in Cisco Unified Communications Manager?A . A partition can have multiple time schedules assigned. A time schedule contains one or more time periods.B . A partition can have one time schedule assigned. A time schedule contains...

October 25, 2021 No Comments READ MORE +

Which configuration is occurring in this section?

An administrator sees the voice register pool 1 command in a Cisco UCME configuration . Which configuration is occurring in this section?A . configuration for a pool of SIP phones (similar to device pool on Cisco UCM)B . configuration for a single SIP phoneC . configuration for SIP registrar serviceD...

October 25, 2021 No Comments READ MORE +

Which DTMF method must be configured in resolve the issue?

A new deployment is using MVA for a specific user on the sales team, but the user is having issues when dialing DTMF . Which DTMF method must be configured in resolve the issue?A . gatewayB . out-of-bandC . channelD . in-bandView AnswerAnswer: B

October 25, 2021 No Comments READ MORE +