300-615 V2

An engineer configures FCoE between a set of ESXi hosts and a Cisco Nexus 5000 Series Switch. The Converged Network Adapter of the host fails to receive the response from the Cisco Nexus device. Also, the VFC interface is in a down state and the FIP adapter fails to receive...

Refer to the exhibit. A network engineer upgrades the firmware of a Cisco Fabric Interconnect from boot flash. During the process, the fabric interconnect reboots and displays the message shown in the exhibit. Which action resolves the issue?A . Remove the service pack and upgrade through the auto-install procedure B....

Refer to the exhibit. The job fails to run. Which action resolves the issue?A . Configure an NTP server B. Add a start time to the script C. Renew the feature license D. Enable the feature requiredView AnswerAnswer: D

Refer to the exhibit. A network engineer notices packet drops on FCoE traffic from the servers. Which action resolves the issue?A . Apply flowcontrol receive on the interface. B. Apply flowcontrol transmit on the interface. C. Enable priority flow control on the interface. D. Disable priority flow control on the...

Refer to the exhibit. An engineer must strictly enforce the port security configuration database in the Fibre Channel fabric. A new device has been connected to the Fibre Channel storage interface that was configured for port security. The port security was enabled for the VSAN that the port belongs to....

An upgrade of protected RPMs from the Bash shell did not take effect. Which action is required for the changes to take effect?A . Restart the Bash shell. B. Reload the switch. C. Upgrade the RPMs from the Guest shell. D. Disable and reenable the Bash feature.View AnswerAnswer: A

Refer to the exhibit. An engineer must save the running configuration to startup-config and generate a syslog message indicating that the configuration was modified, but an error was received. Which action resolves the issue?A . Change the syslog action number to 1. B. Save the configuration using a user with...

Refer to the exhibit. An engineer configures the server port on a Cisco Nexus 5000 Series Switch. The switch connects to an NPV edge switch port. The server fails to send the FC traffic to the fabric. Which action resolves the issue?A . Enable the NPIV mode on the Cisco...

A request to activate the port security database is rejected. Which action do you perform to investigate the cause of the issue?A . Enable the auto-learning feature. B. Use the force option to identify rejected devices. C. Find conflicting entries between the active and configuration databases. D. Verify that devices...

Refer to the exhibit. An engineer discovers that if the vPC peer link goes down, half of the devices in VLAN 20 experience connectivity issues with the external networks. Which action resolves the issue?A . Configure a dedicated Layer 3 link between vPC peers B. Allow non-vPC VLANs on a...