- All Exams Instant Download
Which settings must be added to resolv.conf file to resolve the issue?
A network engineer discovers a DNS resolution problem on a device that is using the Cisco Nexus Bash shell. The device name is app with an IP address of 10.10.10.1. The primary server IP address is 172.16.10.1 and the secondary server IP address is 172.16.10.2. When the abc.com resolution fails,...
What is a possible cause of the issue?
Refer to the exhibit. When an engineer inserts 8-Gb FC SFP port 15 on a Cisco UCS Fabric Interconnect, the port fails . What is a possible cause of the issue?A . Port 15 is configured as an Ethernet port.B . Port 15 is configured for 4-Gb FD . Port...
Which action resolves the issue?
Refer to the exhibit. An engineer configures the server port on a Cisco Nexus 5000 Series Switch. The switch connects to an NPV edge switch port. The server fails to send the FC traffic to the fabric . Which action resolves the issue?A . Enable the NPIV mode on the...
Which action resolves the issue?
Cisco Unified Computing System Manager raises a critical error message that indicates that the system has overlapping Ethernet and FCoE VLANs. All of the Ethernet traffic on the overlapping VLANs drops . Which action resolves the issue?A . Modify the VLAN assignment to vNICs.B . Change the PIN groups on...
Which action resolves the connectivity issue?
Refer to the exhibit. An engineer is troubleshooting the connectivity between Server-1 and Server-2 . Which action resolves the connectivity issue?A . Enable BGP advertise pip feature on both leaf switchesB . Configure the same source IP address on NVE and virtual peer link on leaf switchesC . Classify CFS...
Which action resolves the issue?
A system administrator adds two vNICs to an existing service profile that is used to run a vSphere environment to support disjoint Layer 2 network connectivity. However, after the server is rebooted, the host is not accessible on the network. Which action resolves the issue?A . Remove all existing vNICs...
Which action resolves the issue?
Refer to the exhibit. An OSPF adjacency between Router-A and Router-B cannot reach the FULL state . Which action resolves the issue?A . Adjust the MTU on Router-A to 1600.B . Disable the check of the MTU value.C . Set the OSPF media type to point-to-point.D . Adjust the MTU...
Which action resolves the issue?
Refer to the exhibit. A network engineer upgrades the firmware of a Cisco Fabric Interconnect from boot flash. During the process, the fabric interconnect reboots and displays the message shown in the exhibit . Which action resolves the issue?A . Remove the service pack and upgrade through the auto-install procedureB...
Refer to the exhibit.
Refer to the exhibit. During implementation of a Cisco UCS C-Series Server, an engineer receives the status that is shown in the exhibit . Which action resolves the issue.A . Reconfigure the Drive Type from "Removable" to "Non-Removable"B . Insert an SD card into SLOT-2C . Configure the RAID that...
Which two actions resolve the issue?
An engineer must place a Cisco UCS B-Series Server in a single server pool in Cisco UCS Manager. The engineer creates a qualification policy, but the server is still seen in multiple pools . Which two actions resolve the issue? (Choose two.)A . Select the Server Pool Policy Qualification from...
