- All Exams Instant Download
What is the reason for the error?
When provisioning a device in Cisco DNA Center, the engineer sees the error message “Cannot select the device. Not compatible with template”. What is the reason for the error?A . The template has an incorrect configuration. B. The software version of the template is different from the software version of...
Which action can the engineer take to solve the issue so that all the PCs are reachable?
Refer to the exhibit. After redistribution is enabled between the routing protocols; PC2, PC3, and PC4 cannot reach PC1. Which action can the engineer take to solve the issue so that all the PCs are reachable?A . Set the administrative distance 100 under the RIP process on R2. B. Filter...
Which action resolves this issue?
Refer to the exhibit. AAA server 10.1.1.1 is configured with the default authentication and accounting settings, but the switch cannot communicate with the server. Which action resolves this issue?A . Match the authentication port B. Match the accounting port C. Correct the timeout value. D. Correct the shared secret.View AnswerAnswer:...
Which command must be configured first to troubleshoot this issue?
While troubleshooting connectivity issues to a router, these details are noticed: - Standard pings to all router interfaces, including loopbacks, are successful. - Data traffic is unaffected. - SNMP connectivity is intermittent. - SSH is either slow or disconnects frequently. Which command must be configured first to troubleshoot this issue?A...
Which statement about MPLS LDP router ID is true?
Which statement about MPLS LDP router ID is true?A . If not configured, the operational physical interface is chosen as the router ID even if a loopback is configured. B. The loopback with the highest IP address is selected as the router ID. C. The MPLS LDP router ID must...
Which statement about route distinguishers in an MPLS network is true?
Which statement about route distinguishers in an MPLS network is true?A . Route distinguishers allow multiple instances of a routing table to coexist within the edge router. B. Route distinguishers are used for label bindings. C. Route distinguishers make a unique VPNv4 address across the MPLS network. D. Route distinguishers...
Which action ensures consistency between the two times?
Refer to the exhibit. An engineer is troubleshooting BGP on a device but discovers that the clock on the device does not correspond to the time stamp of the log entries. Which action ensures consistency between the two times?A . Configure the service timestamps log uptime command in global configuration...
Drag and drop the packet types from the left onto the correct descriptions on the right
DRAG DROP Drag and drop the packet types from the left onto the correct descriptions on the right. View AnswerAnswer: Explanation: Unlike legacy network technologies such as ISDN, Frame Relay, and ATM that defined separate data and control channels, IP carries all packets within a single pipe. Thus, IP network...
Which command must the engineer run to correct the configuration?
An engineer configured the wrong default gateway for the Cisco DNA Center enterprise interface during the install. Which command must the engineer run to correct the configuration?A . sudo maglev-config update B. sudo maglev install config update C. sudo maglev reinstall D. sudo update config installView AnswerAnswer: A
Which action resolves intermittent connectivity observed with the SNMP trappackets?
Refer the exhibit. Which action resolves intermittent connectivity observed with the SNMP trappackets?A . Decrease the committed burst Size of the mgmt class map B. Increase the CIR of the mgmt class map C. Add a new class map to match TCP traffic D. Add one new entry in the...
