- All Exams Instant Download
Which configuration enabled the VRF that is labeled “Inet” on FastEthernet0/0?
Which configuration enabled the VRF that is labeled “Inet” on FastEthernet0/0?A . R1(config)# ip vrf Inet R1(config-vrf)#interface FastEthernet0/0 R1(config-if)#ip vrf forwarding Inet B. R1(config)#router ospf 1 vrf Inet R1(config-router)#ip vrf forwarding FastEthernet0/0 C. R1(config)#ip vrf Inet FastEthernet0/0 D. R1(config)# ip vrf Inet R1(config-vrf)#ip vrf FastEthernet0/0View AnswerAnswer: A
Which subnet is redistributed from EIGRP to OSPF routing protocols?
Refer to the exhibit. Which subnet is redistributed from EIGRP to OSPF routing protocols?A . 10.2.2.0/24 B. 10.1.4.0/26 C. 10.1.2.0/24 D. 10.2.3.0/26View AnswerAnswer: A
Drag and drop the packet types from the left onto the correct descriptions on the right
DRAG DROP Drag and drop the packet types from the left onto the correct descriptions on the right. View AnswerAnswer: Explanation: Unlike legacy network technologies such as ISDN, Frame Relay, and ATM that defined separate data and control channels, IP carries all packets within a single pipe. Thus, IP network...
Which two actions are needed to allow the file to copy?
An engineer is trying to copy an IOS file from one router to another router by using TFTP. Which two actions are needed to allow the file to copy? (Choose two.)A . Copy the file to the destination router with the copy tftp: flash: command B. Enable the TFTP server...
Which command must be used in configuration mode to enable SSH on the device?
Refer to the exhibit. An engineer is trying to connect to a device with SSH but cannot connect. The engineer connects by using the console and finds the displayed output when troubleshooting. Which command must be used in configuration mode to enable SSH on the device?A . no ip ssh...
Which configuration denies Telnet traffic to router 2 from 198A:0:200C::1/64?
Refer to the exhibit. Which configuration denies Telnet traffic to router 2 from 198A:0:200C::1/64? A) B) C) D) A . Option A B. Option B C. Option C D. Option DView AnswerAnswer: A
Drag and drop the addresses from the left onto the correct IPv6 filter purposes on the right
DRAG DROP Drag and drop the addresses from the left onto the correct IPv6 filter purposes on the right. View AnswerAnswer: Explanation: HTTP and HTTPs run on TCP port 80 and 443, respectively and we have to remember them. Syslog runs on UDP port 514 while NTP runs on UDP...
Drag and drop the DHCP messages from the left onto the correct uses on the right
DRAG DROP Drag and drop the DHCP messages from the left onto the correct uses on the right. View AnswerAnswer: DHCPNAK The server-to-client communication, refuses the request for configuration parameter. DHCPINFORM The client-to-server communication, asks for only local configuration parameters that the client already has externally configured as an address....
Drag and drop the operations from the left onto the locations where the operations are performed on the right
DRAG DROP Drag and drop the operations from the left onto the locations where the operations are performed on the right. View AnswerAnswer: Explanation: Label Switch Router
Drag and drop the packet types from the left onto the correct descriptions on the right
DRAG DROP Drag and drop the packet types from the left onto the correct descriptions on the right. View AnswerAnswer: Explanation: Unlike legacy network technologies such as ISDN, Frame Relay, and ATM that defined separate data and control channels, IP carries all packets within a single pipe. Thus, IP network...
