Drag and drop the MPLS VPN concepts from the left onto the correct descriptions on the right

DRAG DROP Drag and drop the MPLS VPN concepts from the left onto the correct descriptions on the right. View AnswerAnswer: Explanation: Reference: https://www.rogerperkin.co.uk/featured/route-distinguisher-vs-route-target/

September 30, 2022 No Comments READ MORE +

What action forwards the packets through 10.1.1.1?

Refer to the exhibit. An engineer is trying to get 192.168.32.100 forwarded through 10.1.1.1, but it was forwarded through 10.1.1.2. What action forwards the packets through 10.1.1.1?A . Configure EIGRP to receive 192.168.32.0 route with lower admin distance. B.Configure EIGRP to receive 192.168.32.0 route with longer prefix than /19. C.Configure...

September 30, 2022 No Comments READ MORE +

What is a prerequisite for configuring BFD?

What is a prerequisite for configuring BFD?A . Jumbo frame support must be configured on the router that is using BFD. B. All routers in the path between two BFD endpoints must have BFD enabled. C. Cisco Express Forwarding must be enabled on all participating BFD endpoints. D. To use...

September 30, 2022 No Comments READ MORE +

Which two configurations will fix it?

An engineer configured a leak-map command to summarize EIGRP routes and advertise specifically loopback 0 with an IP of 10.1.1.1.255.255.255.252 along with the summary route. After finishing configuration, the customer complained not receiving summary route with specific loopback address. Which two configurations will fix it? (Choose two.)A . Configure access-list...

September 30, 2022 No Comments READ MORE +

Which command is missing from the IP SLA configuration?

Refer to the exhibit. ISP 1 and ISP 2 directly connect to the Internet. A customer is tracking both ISP links toachieve redundancy and cannot see the Cisco IOS IP SLA tracking output on the router console. Which command is missing from the IP SLA configuration?A . Start-time 00:00 B....

September 30, 2022 No Comments READ MORE +

Drag and drop the packet types from the left onto the correct descriptions on the right

DRAG DROP Drag and drop the packet types from the left onto the correct descriptions on the right. View AnswerAnswer: Explanation: Unlike legacy network technologies such as ISDN, Frame Relay, and ATM that defined separate data and control channels, IP carries all packets within a single pipe. Thus, IP network...

September 30, 2022 No Comments READ MORE +

In which circumstance does the BGP neighbor remain in the idle condition?

Refer to the exhibit. In which circumstance does the BGP neighbor remain in the idle condition?A . if prefixes are not received from the BGP peer B. if prefixes reach the maximum limit C. if a prefix list is applied on the inbound direction D. if prefixes exceed the maximum...

September 30, 2022 No Comments READ MORE +

What is the reason for this issue?

Refer to the exhibit. An engineer is trying to redistribute OSPF to BGP, but not all of the routes areredistributed. What is the reason for this issue?A . By default, only internal routes and external type 1 routes are redistributed into BGP B. Only classful networks are redistributed from OSPF...

September 30, 2022 No Comments READ MORE +

Drag and drop the operations from the left onto the locations where the operations are performed on the right

DRAG DROP Drag and drop the operations from the left onto the locations where the operations are performed on the right. View AnswerAnswer: Explanation: Label Switch Router

September 29, 2022 No Comments READ MORE +

Which list defines the contents of an MPLS label?

Which list defines the contents of an MPLS label?A . 20-bit label; 3-bit traffic class; 1-bit bottom stack; 8-bit TTL B. 32-bit label; 3-bit traffic class; 1-bit bottom stack; 8-bit TTL C. 20-bit label; 3-bit flow label; 1-bit bottom stack; 8-bit hop limit D. 32-bit label; 3-bit flow label; 1-bit...

September 29, 2022 No Comments READ MORE +