- All Exams Instant Download
Refer to the exhibit
DRAG DROP Refer to the exhibit. Drag and drop the credentials from the left onto the remote login information on the right to resolve a failed login attempt to vtys. Not all credentials are uf SLA by defining frequency and schedulingsed View AnswerAnswer: Explanation: vty 0: + cisco + 0csic...
What are the two solutions to fix the issue?
Exhibit: BGP is flapping after the Copp policy is applied. What are the two solutions to fix the issue? (Choose two)A . Configure BGP in the COPP-CRITICAL-7600 ACLB . Configure a higher value for CIR under the default class to allow more packets during peak trafficC . Configure a higher...
Which method changes the forwarding decision that a router makes without first changing the routing table or influencing the IP data plane?
Which method changes the forwarding decision that a router makes without first changing the routing table or influencing the IP data plane?A . nonbroadcast multiaccessB . packet switchingC . policy-based routingD . forwarding information baseView AnswerAnswer: C
Which command must the engineer run to correct the configuration?
An engineer configured the wrong default gateway for the Cisco DNA Center enterprise interface during the install. Which command must the engineer run to correct the configuration?A . sudo maglev-config updateB . sudo maglev install config updateC . sudo maglev reinstallD . sudo update config installView AnswerAnswer: A
Which list defines the contents of an MPLS label?
Which list defines the contents of an MPLS label?A . 20-bit label; 3-bit traffic class; 1-bit bottom stack; 8-bit TTLB . 32-bit label; 3-bit traffic class; 1-bit bottom stack; 8-bit TTLC . 20-bit label; 3-bit flow label; 1-bit bottom stack; 8-bit hop limitD . 32-bit label; 3-bit flow label; 1-bit...
Why is the summary route missing?
Refer to the exhibit. An engineer is trying to generate a summary route in OSPF for network 10.0.0.0/8, but the summary route does not show up in the routing table. Why is the summary route missing?A . The summary-address command is used only for summarizing prefixes between areas.B . The...
Which debug command is used to troubleshoot this issue?
Refer to the exhibit. An IP SLA was configured on router R1 that allows the default route to be modified in the event that Fa0/0 loses reachability with the router R3 Fa0/0 interface. The route has changed to flow through router R2. Which debug command is used to troubleshoot this...
In which circumstance does the BGP neighbor remain in the idle condition?
Refer to the exhibit. In which circumstance does the BGP neighbor remain in the idle condition?A . if prefixes are not received from the BGP peerB . if prefixes reach the maximum limitC . if a prefix list is applied on the inbound directionD . if prefixes exceed the maximum...
Which statement about R1 is true?
Refer to the exhibit. Which statement about R1 is true?A . OSPF redistributes RIP routes only if they have a tag of one.B . RIP learned routes are distributed to OSPF with a tag value of one.C . R1 adds one to the metric for RIP learned routes before redistributing...
What is the reason for this error?
Refer to the exhibit. An administrator noticed that after a change was made on R1, the timestamps on the system logs did not match the clock. What is the reason for this error?A . An authentication error with the NTP server results in an incorrect timestamp.B . The keyword localtime...
