- All Exams Instant Download
Which command enables a router to become a DHCP client?
Which command enables a router to become a DHCP client?A . ip address dhcpB . ip helper-addressC . ip dhcp poolD . ip dhcp clientView AnswerAnswer: A Explanation: Reference: https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/ipaddr_dhcp/configuration/12-4/dhcp-12-4-book/config-dhcp-client.html If we want to get an IP address from the DHCP server on a Cisco device, we can use the...
What is the primary purpose of a First Hop Redundancy Protocol?
What is the primary purpose of a First Hop Redundancy Protocol?A . It allows directly connected neighbors to share configuration information.B . It allows a router to use bridge priorities to create multiple loop-free paths to a single destination.C . It reduces routing failures by allowing Layer 3 load balancing...
Which statement explains the configuration error message that is received?
Refer to exhibit. Which statement explains the configuration error message that is received?A . It is a broadcast IP addressB . The router does not support /28 mask.C . It belongs to a private IP address range.D . IT is a network IP address.View AnswerAnswer: A
Which type of attack can be mitigated by dynamic ARP inspection?
Which type of attack can be mitigated by dynamic ARP inspection?A . wormB . malwareC . DDoSD . man-in-the-middleView AnswerAnswer: D
Which output displays a JSON data representation?
Which output displays a JSON data representation? A) B) C) D) A . Option AB . Option BC . Option CD . Option DView AnswerAnswer: C Explanation: JSON data is written as name/value pairs. A name/value pair consists of a field name (in double quotes), followed by a colon, followed...
Which command is used to specify the delay time in seconds for LLDP to initialize on any interface?
Which command is used to specify the delay time in seconds for LLDP to initialize on any interface?A . lldp timerB . lldp holdtimtC . lldp reinitD . lldp tlv-selectView AnswerAnswer: C Explanation: Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst2960/software/release/12-2_37_ey/configuration/guide/scg/swlldp.pdf + lldp holdtime seconds: Specify the amount of time a receiving device should hold the...
If the network environment is operating normally, which type of device must be connected to interface FastEthernet 0/1?
Refer to the exhibit. ip arp inspection vlan 2-10 interface fastethernet 0/1 ip arp inspection trust If the network environment is operating normally, which type of device must be connected to interface FastEthernet 0/1?A . DHCP clientB . access pointC . routerD . PCView AnswerAnswer: C
Which path is used by the router for internet traffic?
Refer to the exhibit. Which path is used by the router for internet traffic?A . 209.165.200.0/27B . 10.10.10.0/28C . 0.0.0.0/0D . 10.10.13.0/24View AnswerAnswer: C
What are two benefits of controller-based networking compared to traditional networking?
What are two benefits of controller-based networking compared to traditional networking?A . controller-based increases network bandwidth usage, while traditional lightens the load on the network.B . controller-based inflates software costs, while traditional decreases individual licensing costsC . Controller-based reduces network configuration complexity, while traditional increases the potential for errorsD ....
What is the primary effect of the spanning-tree portfast command?
What is the primary effect of the spanning-tree portfast command?A . it enables BPDU messagesB . It minimizes spanning-tree convergence timeC . It immediately puts the port into the forwarding state when the switch is reloadedD . It immediately enables the port in the listening stateView AnswerAnswer: B Explanation: Reference:...
