- All Exams Instant Download
Drag and drop the network protocols from the left onto the correct transport services on the right
DRAG DROP Drag and drop the network protocols from the left onto the correct transport services on the right. View AnswerAnswer:
What criteria is used first during me root port selection process?
What criteria is used first during me root port selection process?A . local port ID B. lowest path cost to the root bridge C. lowest neighbor's bridge ID D. lowest neighbor's port IDView AnswerAnswer: B
When PC-A sends traffic to PC-B, which network component is in charge of receiving the packet from PC-A verifying the IP addresses, and forwarding the packet to PC-B?
Refer to the exhibit. When PC-A sends traffic to PC-B, which network component is in charge of receiving the packet from PC-A verifying the IP addresses, and forwarding the packet to PC-B?A . Layer 2 switch B. Router C. Load balancer D. firewallView AnswerAnswer: B Explanation: PC--A and PC-B are...
What is the difference regarding reliability and communication type between TCP and UDP?
What is the difference regarding reliability and communication type between TCP and UDP?A . TCP is reliable and is a connection-oriented protocol UDP is not reliable and is a connectionless protocol B. TCP is not reliable and is a connection-oriented protocol; UDP is reliable and is a connectionless protocol C....
Which action does the router take as it forwards a packet through the network?
Which action does the router take as it forwards a packet through the network?A . The router replaces the original source and destination MAC addresses with the sending router MAC address as the source and neighbor MAC address as the destination B. The router encapsulates the original packet and then...
Which implementation provides the strongest encryption combination for the wireless environment?
Which implementation provides the strongest encryption combination for the wireless environment?A . WPA2 + AES B. WPA + AES C. WEP D. WPA + TKIPView AnswerAnswer: A
What commands are needed to add a subinterface to Ethernet0/0 on R1 to allow for VLAN 20, with IP address 10.20.20.1/24?
Refer to the exhibit. What commands are needed to add a subinterface to Ethernet0/0 on R1 to allow for VLAN 20, with IP address 10.20.20.1/24?A . R1(config)#interface ethernet0/0 R1(config)#encapsulation dot1q 20 R1(config)#ip address 10.20.20.1 255.255.255.0 B. R1(config)#interface ethernet0/0.20 R1(config)#encapsulation dot1q 20 R1(config)#ip address 10.20.20.1 255.255.255.0 C. R1(config)#interface ethernet0/0.20 R1(config)#ip address...
