200-301

What are two reasons that cause late collisions to increment on an Ethernet interface? (Choose two.)A . when Carrier Sense Multiple Access/Collision Detection is usedB . when one side of the connection is configured for half-duplexC . when the sending device waits 15 seconds before sending the frame againD ....

Refer to the exhibit. Which password must an engineer use to enter the enable mode?A . adminadmin123B . cisco123C . defaultD . testing1234View AnswerAnswer: D

What is the default behavior of a Layer 2 switch when a frame with an unknown destination MAC address is received?A . The Layer 2 switch forwards the packet and adds the destination MAC address to its MAC address table.B . The Layer 2 switch sends a copy of a...

Refer to the exhibit. Which command provides this output?A . show ip routeB . show cdp neighborC . show ip interfaceD . show interfaceView AnswerAnswer: B

DRAG DROP Drag and drop the descriptions of file-transfer protocols from the left onto the correct protocols on the right. View AnswerAnswer:

Which IPv6 address block sends packets to a group address rather than a single address?A . 2000::/3B . FC00::/7C . FE80::/10D . FF00::/8View AnswerAnswer: D

Refer to the exhibit. Which command provides this output?A . show ip routeB . show cdp neighborC . show ip interfaceD . show interfaceView AnswerAnswer: B

Refer to the exhibit. Based on the LACP neighbor status, in which mode is the SW1 port channel configured?A . mode onB . activeC . passiveD . autoView AnswerAnswer: B

A frame that enters a switch fails the Frame Check Sequence. Which two interface counters are incremented? (Choose two.)A . input errorsB . frameC . giantsD . CRCE . runtsView AnswerAnswer: AD

Refer to the exhibit. Which prefix does Router1 use to Host A?A . 10.10.10.0/28B . 10.10.13.0/25C . 10.10.13.144/28D . 10.10.13.208/29View AnswerAnswer: D