Based on the LACP neighbor status, in which mode is the SW1 port channel configured?

Refer to the exhibit. Based on the LACP neighbor status, in which mode is the SW1 port channel configured?A . passiveB . mode onC . autoD . activeView AnswerAnswer: D

September 27, 2020 No Comments READ MORE +

Which action is taken by the phone?

A Cisco IP phone receive untagged data traffic from an attached PC . Which action is taken by the phone?A . It allows the traffic to pass through unchangedB . It drops the trafficC . It tags the traffic with the default VLAND . It tags the traffic with the...

September 27, 2020 No Comments READ MORE +

Which two actions are performed by the Weighted Random Early Detection mechanism? (Choose two)

Which two actions are performed by the Weighted Random Early Detection mechanism? (Choose two)A . It drops lower-priority packets before it drops higher-priority packetsB . It can identify different flows with a high level of granularityC . It guarantees the delivery of high-priority packetsD . It can mitigate congestion by...

September 27, 2020 No Comments READ MORE +

Which WPA3 enhancement protects against hackers viewing traffic on the Wi-Fi network?

Which WPA3 enhancement protects against hackers viewing traffic on the Wi-Fi network?A . TKIP encryptionB . SAE encryptionC . AES encryptionD . scrambled encryption keyView AnswerAnswer: B

September 27, 2020 No Comments READ MORE +

Which mode must be used to configure EtherChannel between two switches without using a negotiation protocol?

Which mode must be used to configure EtherChannel between two switches without using a negotiation protocol?A . onB . autoC . activeD . desirableView AnswerAnswer: A

September 27, 2020 No Comments READ MORE +

Which API is used in controller-based architectures to interact with edge devices?

Which API is used in controller-based architectures to interact with edge devices?A . overlayB . northboundC . underlayD . southboundView AnswerAnswer: D

September 26, 2020 No Comments READ MORE +

Which command prevents passwords from being stored in the configuration as plaintext on a router or switch?

Which command prevents passwords from being stored in the configuration as plaintext on a router or switch?A . enable secretB . service password-encryptionC . username Cisco password encryptD . enable passwordView AnswerAnswer: B

September 26, 2020 No Comments READ MORE +

Which function dose the range of private IPv4 addresses perform?

Which function dose the range of private IPv4 addresses perform?A . allow multiple companies to each use the same address without conflictsB . provides a direct connection for hosts from outside of the enterprise networkC . ensues that NAT is not required to reach the internet with private range addressingD...

September 26, 2020 No Comments READ MORE +

Which function does an SNMP agent perform?

Which function does an SNMP agent perform?A . It manages routing between Layer 3 devices in a network,B . It coordinates user authentication between a network device and a TACACS+ or RADIUS server.C . It sends information about MIB variables in response to requests from the NME . It requests...

September 26, 2020 No Comments READ MORE +

Which two routes dose the router install in the routing table?

Refer to the exhibit. A router received these five routes form different routing information sources. Which two routes dose the router install in the routing table? (choose two)A . iBGP route 10.0.0.0/30B . RIP route 10.0.0.0/30C . EIGRP route 10.0.0.1/32D . OSPF route 10.0.0.0/30E . OSPF route 10.0.0.0/16View AnswerAnswer: CE

September 25, 2020 No Comments READ MORE +