- All Exams Instant Download
Which two tasks must be performed to configure NTP to a trusted server in client mode on a single network device? (Choose two)
Which two tasks must be performed to configure NTP to a trusted server in client mode on a single network device? (Choose two)A . Enable NTP authenticationB . Verify the time zoneC . Disable NTP broadcastsD . Specify the IP address of the NTP serverE . Set the NTP server...
Which command accomplishes this task?
The network administrator wants VLAN 67 traffic to be untagged between Switch 1 and Switch 2 while all other VLANs are to remain tagged . Which command accomplishes this task?A . switchport access vlan 67B . switchport trunk allowed vlan 67C . switchport private-vlan association host 67D . switchport trunk...
Which two routes dose the router install in the routing table?
Refer to the exhibit. A router received these five routes form different routing information sources. Which two routes dose the router install in the routing table? (choose two)A . iBGP route 10.0.0.0/30B . RIP route 10.0.0.0/30C . EIGRP route 10.0.0.1/32D . OSPF route 10.0.0.0/30E . OSPF route 10.0.0.0/16View AnswerAnswer: CE
Which two interface counters are incremented?
A fram that enters a switch fails the Frame Check Sequence. Which two interface counters are incremented?A . input errosB . frameC . giantsD . CRCE . runtsView AnswerAnswer: AD
In which way does a spine-and-leaf architecture allow for scalability in a network when additional access ports are required?
In which way does a spine-and-leaf architecture allow for scalability in a network when additional access ports are required?A . A spine switch and a leaf switch can be added with redundant connections between themB . A spine switch can be added with at least 40 GB uplinksC . A...
which two minimum parameters must be configured on an active interface to enable OSPFv2 to operate? (choose two)
which two minimum parameters must be configured on an active interface to enable OSPFv2 to operate? (choose two)A . IPv6 addressB . OSPF process IDC . OSPF MD5 authentication keyD . OSPF stub flagE . OSPF areaView AnswerAnswer: BE
What is a difference between RADIUS and TACACS+?
What is a difference between RADIUS and TACACS+?A . TACACS+ encrypts only password information and RADIUS encrypts the entire payloadB . RADIUS logs all commands that are entered by the administrator, but TACACS+ logs only start, stop, and interim commandsC . RADIUS is most appropriate for dial authentication, but TACACS+...
When OSPF learns multiple paths to a network, how does it select a route?
When OSPF learns multiple paths to a network, how does it select a route?A . It multiple the active K value by 256 to calculate the route with the lowest metric.B . For each existing interface, it adds the metric from the source router to the destination to calculate the...
Which IPv6 address type provides communication between subnets and cannot route on the internet?
Which IPv6 address type provides communication between subnets and cannot route on the internet?A . link-localB . unique localC . multicastD . global unicastView AnswerAnswer: B
When a site-to-site VPN is used, which protocol is responsible for the transport of user data?
When a site-to-site VPN is used, which protocol is responsible for the transport of user data?A . IKEv2B . IKEv1C . IPsecD . MD5View AnswerAnswer: C
