- All Exams Instant Download
By default, which OSPF network type is seen on this interface when the user types show ip ospf interface on R1 or R2?
A user configured OSPF in a single area between two routers A serial interface connecting R1 and R2 is running encapsulation PPP. By default, which OSPF network type is seen on this interface when the user types show ip ospf interface on R1 or R2?A . point-to-multipointB . broadcastC ....
Which two actions are performed by the Weighted Random Early Detection mechanism? (Choose two)
Which two actions are performed by the Weighted Random Early Detection mechanism? (Choose two)A . It drops lower-priority packets before it drops higher-priority packets.B . It can identify different flows with a high level of granularity.C . It guarantees the delivery of high-priority packets.D . It can mitigate congestion by...
Which protocol allows the engineer to perform this function using the Cisco IOS MIB?
A network engineer must back up 20 network router configurations globally within a customer environment. Which protocol allows the engineer to perform this function using the Cisco IOS MIB?A . CDPB . SNMPC . SMTPD . ARPView AnswerAnswer: B Explanation: SNMP is an application-layer protocol that provides a message format...
Which two actions are performed by the Weighted Random Early Detection mechanism? (Choose two)
Which two actions are performed by the Weighted Random Early Detection mechanism? (Choose two)A . It drops lower-priority packets before it drops higher-priority packets.B . It can identify different flows with a high level of granularity.C . It guarantees the delivery of high-priority packets.D . It can mitigate congestion by...
How do TCP and UDP differ in the way that they establish a connection between two endpoints?
How do TCP and UDP differ in the way that they establish a connection between two endpoints?A . TCP uses synchronization packets, and UDP uses acknowledgment packets.B . UDP uses SYN, SYN ACK and FIN bits in the frame header while TCP uses SYN, SYN ACK and ACK bits.C ....
Which two tasks must be performed so that the Serial0/0/0 interfaces on the Atlanta and Washington routers can reach one another?
Refer to the exhibit. The New York router is configured with static routes pointing to the Atlanta and Washington sites. Which two tasks must be performed so that the Serial0/0/0 interfaces on the Atlanta and Washington routers can reach one another? (Choose two.)A . Configure the ipv6 route 2012::/126 2023::1...
Which two encoding methods are supported by REST APIs? (Choose two)
Which two encoding methods are supported by REST APIs? (Choose two)A . YAMLB . JSONC . EBCDICD . SGMLE . XMLView AnswerAnswer: BE Explanation: The Application Policy Infrastructure Controller (APIC) REST API is a programmatic interface that uses REST architecture. The API accepts and returns HTTP (not enabled by default)...
What does router R1 use as its OSPF router-ID?
Refer to the exhibit. What does router R1 use as its OSPF router-ID?A . 10.10.1.10B . 10.10.10.20C . 172.16.15.10D . 192.168.0.1View AnswerAnswer: C Explanation: OSPF uses the following criteria to select the router ID:
Which prefix does Router 1 use for traffic to Host A?
Refer to the exhibit. Which prefix does Router 1 use for traffic to Host A?A . 10.10.10.0/28B . 10.10.13.0/25C . 10.10.13.144/28D . 10.10.13.208/29View AnswerAnswer: D Explanation: Host A address fall within the address range. However, if more than one route to the same subnet exist (router will use the longest...
What are two reasons that cause late collisions to increment on an Ethernet interface? (Choose two)
What are two reasons that cause late collisions to increment on an Ethernet interface? (Choose two)A . when the sending device waits 15 seconds before sending the frame againB . when the cable length limits are exceededC . when one side of the connection is configured for half-duplexD . when...
