- All Exams Instant Download
What is the result of this configuration?
Two switches are connected and using Cisco Dynamic Trunking Protocol SW1 is set to Dynamic Desirable. What is the result of this configuration?A . The link is in a down stateB . The link is in an error disables stateC . The link is becomes an access portD . The...
Which two steps will fulfill the request?
An engineer is asked to protect unused ports that are configured in the default VLAN on a switch. Which two steps will fulfill the request? (Choose two)A . Configure the ports in an EtherChannelB . Administratively shut down the portsC . Configure the port type as access and place in...
If configuring a static default route on the router with the ip route 0.0.0.0 0.0.0.0 10 . 13.0.1 120 command, how does the router respond?
Refer to the exhibit. If configuring a static default route on the router with the ip route 0.0.0.0 0.0.0.0 10 . 13.0.1 120 command, how does the router respond?A . It ignores the new static route until the existing OSPF default route is removedB . It immediately replaces the existing...
Which set of action satisfy the requirement for multifactor authentication?
Which set of action satisfy the requirement for multifactor authentication?A . The user swipes a key fob, then clicks through an email linkB . The user enters a user name and password, and then clicks a notification in an authentication app on a mobile deviceC . The user enters a...
What does router R1 use as its OSPF router-ID?
Refer to the exhibit. What does router R1 use as its OSPF router-ID?A . 10.10.1.10B . 10.10.10.20C . 172.16.15.10D . 192.168.0.1View AnswerAnswer: C Explanation: OSPF uses the following criteria to select the router ID:
Which type of address is the public IP address of a NAT device?
Which type of address is the public IP address of a NAT device?A . outside globalB . outsdwde localC . inside globalD . insride localE . outside publicF . inside publicView AnswerAnswer: C Explanation: NAT use four types of addresses: * Inside local address C. The IP address assigned to...
Which two outcomes are predictable behaviors for HSRP? (Choose two)
Which two outcomes are predictable behaviors for HSRP? (Choose two)A . The two routers share a virtual IP address that is used as the default gateway for devices on the LANB . The two routers negotiate one router as the active router and the other as the standby routerC ....
How is OSPF configured?
Refer to the exhibit. The show ip ospf interface command has been executed on R1. How is OSPF configured?A . The interface is not participating in OSPFB . A point-to-point network type is configuredC . The default Hello and Dead timers are in useD . There are six OSPF neighbors...
Which two must be met before SSH can operate normally on a Cisco IOS switch? (Choose two)
Which two must be met before SSH can operate normally on a Cisco IOS switch? (Choose two)A . The switch must be running a k9 (crypto) IOS imageB . The ip domain-name command must be configured on the switchC . IP routing must be enabled on the switchD . A...
When OSPF learns multiple paths to a network, how does it select a route?
When OSPF learns multiple paths to a network, how does it select a route?A . It multiple the active K value by 256 to calculate the route with the lowest metricB . For each existing interface, it adds the metric from the source router to the destination to calculate the...
