- All Exams Instant Download
Which state verifies the designated router is in the proper mode?
An engineer configured an OSPF neighbor as a designated router. Which state verifies the designated router is in the proper mode?A . ExchangeB . 2-wayC . FullD . InitView AnswerAnswer: C
Which type of route does R1 use to reach host 10.10.13.10/32?
Refer to the exhibit. Which type of route does R1 use to reach host 10.10.13.10/32?A . floating static routeB . host routeC . default routeD . network routeView AnswerAnswer: D Explanation: From the output, we see R1 will use the entry "O 10.10.13.0/25 [110/4576] via 10.10.10.1, ..." to reach host...
What does router R1 use as its OSPF router-ID?
Refer to the exhibit. What does router R1 use as its OSPF router-ID?A . 10.10.1.10B . 10.10.10.20C . 172.16.15.10D . 192.168.0.1View AnswerAnswer: C Explanation: OSPF uses the following criteria to select the router ID:
Which action do the switches take on the trunk link?
Refer to Exhibit. Which action do the switches take on the trunk link?A . The trunk does not form and the ports go into an err-disabled status.B . The trunk forms but the mismatched native VLANs are merged into a single broadcast domain.C . The trunk does not form, but...
What are two characteristics of a controller-based network? (Choose two)
What are two characteristics of a controller-based network? (Choose two)A . The administrator can make configuration updates from the CLC . It uses northbound and southbound APIs to communicate between architectural layers.D . It moves the control plane to a central point.E . It decentralizes the control plane, which allows...
Which type of wireless encryption is used for WPA2 in pre-shared key mode?
Which type of wireless encryption is used for WPA2 in pre-shared key mode?A . TKIP with RC4B . RC4C . AES-128D . AES-256View AnswerAnswer: D Explanation: We can see in this picture we have to type 64 hexadecimal characters (256 bit) for the WPA2 passphrase so we can deduce the...
When configuring IPv6 on an interface, which two IPv6 multicast groups are joined? (Choose two)
When configuring IPv6 on an interface, which two IPv6 multicast groups are joined? (Choose two)A . 2000::/3B . 2002::5C . FC00::/7D . FF02::1E . FF02::2View AnswerAnswer: DE Explanation: When an interface is configured with IPv6 address, it automatically joins the all nodes (FF02::1) and solicited-node (FF02::1:FFxx:xxxx) multicast groups. The all-node...
What does router R1 use as its OSPF router-ID?
Refer to the exhibit. What does router R1 use as its OSPF router-ID?A . 10.10.1.10B . 10.10.10.20C . 172.16.15.10D . 192.168.0.1View AnswerAnswer: C Explanation: OSPF uses the following criteria to select the router ID:
Which two interface counters are incremented?
A frame that enters a switch fails the Frame Check Sequence. Which two interface counters are incremented? (Choose two)A . runtsB . giantsC . frameD . CRCE . input errorsView AnswerAnswer: DE Explanation: Whenever the physical transmission has problems, the receiving device might receive a frame whose bits have changed...
What is the result of this configuration?
Two switches are connected and using Cisco Dynamic Trunking Protocol SW1 is set to Dynamic Desirable. What is the result of this configuration?A . The link is in a down state.B . The link is in an error disables stateC . The link is becomes an access port.D . The...
