- All Exams Instant Download
Which protocol allows the engineer to perform this function using the Cisco IOS MIB?
A network engineer must back up 20 network router configurations globally within a customer environment. Which protocol allows the engineer to perform this function using the Cisco IOS MIB?A . CDPB . SNMPC . SMTPD . ARPView AnswerAnswer: B Explanation: SNMP is an application-layer protocol that provides a message format...
Which mode must be used to configure EtherChannel between two switches without using a negotiation protocol?
Which mode must be used to configure EtherChannel between two switches without using a negotiation protocol?A . onB . autoC . activeD . desirableView AnswerAnswer: A Explanation: The Static Persistence (or “on” mode) bundles the links unconditionally and no negotiation protocol is used. In this mode, neither PAgP nor LACP...
What’s the expected behavior for the traffic flow for route 10.10.13.0/25?
Refer to the exhibit. An engineer is bringing up a new circuit to the MPLS provider on the Gi0/1 interface of Router1. The new circuit uses eBGP and teams the route to VLAN25 from the BGP path. What’s the expected behavior for the traffic flow for route 10.10.13.0/25?A . Traffic...
When a floating static route is configured, which action ensures that the backup route is used when the primary route fails?
When a floating static route is configured, which action ensures that the backup route is used when the primary route fails?A . The floating static route must have a higher administrative distance than the primary route so it is used as a backup.B . The administrative distance must be higher...
Which two encoding methods are supported by REST APIs? (Choose two)
Which two encoding methods are supported by REST APIs? (Choose two)A . YAMLB . JSONC . EBCDICD . SGMLE . XMLView AnswerAnswer: BE Explanation: The Application Policy Infrastructure Controller (APIC) REST API is a programmatic interface that uses REST architecture. The API accepts and returns HTTP (not enabled by default)...
Which two changes stop outbound traffic on TCP ports 25 and 80 to 10.0.20.0/26 from the 10.0.10.0/26 subnet while still allowing all other traffic?
Refer to the exhibit. An extended ACL has been configured and applied to router R2. The configuration started to work as intended. Which two changes stop outbound traffic on TCP ports 25 and 80 to 10.0.20.0/26 from the 10.0.10.0/26 subnet while still allowing all other traffic? (Choose two)A . Add...
Which command provides this output?
Refer to the exhibit. Which command provides this output?A . show ip routeB . show ip interfaceC . show interfaceD . show cdp neighborView AnswerAnswer: D
Which two outcomes are predictable behaviors for HSRP? (Choose two)
Which two outcomes are predictable behaviors for HSRP? (Choose two)A . The two routers share a virtual IP address that is used as the default gateway for devices on the LAC . The two routers negotiate one router as the active router and the other as the standby router.D ....
Which route does R1 select for traffic that is destined to 192 168.16.2?
Refer to the exhibit. Which route does R1 select for traffic that is destined to 192 168.16.2?A . 192.168.16.0/21B . 192.168.16.0/24C . 192.168 26.0/26D . 192.168.16.0/27View AnswerAnswer: D Explanation: The destination IP addresses match all four entries in the routing table but the 192.168.16.0/27 has the longest prefix so it...
Which two values or settings must be entered when configuring a new WLAN in the Cisco Wireless LAN Controller GUI? (Choose two)
Which two values or settings must be entered when configuring a new WLAN in the Cisco Wireless LAN Controller GUI? (Choose two)A . management interface settingsB . QoS settingsC . Ip address of one or more access pointsD . SSIDE . Profile nameView AnswerAnswer: DE
