Cisco 350-401 Implementing and Operating Cisco Enterprise Network Core Technologies (ENCOR) Online Training
Cisco 350-401 Online Training
The questions for 350-401 were last updated at Nov 04,2025.
- Exam Code: 350-401
- Exam Name: Implementing and Operating Cisco Enterprise Network Core Technologies (ENCOR)
- Certification Provider: Cisco
- Latest update: Nov 04,2025
Refer to the exhibit.
What step resolves the authentication issue?
- A . use basic authentication
- B . change the port to 12446
- C . target 192 168 100 82 in the URI
- D . restart the vsmart host
What is required for a virtual machine to run?
- A . a Type 1 hypervisor and a host operating system
- B . a hypervisor and physical server hardware
- C . only a Type 1 hypervisor
- D . only a Type 2 hypervisor
What is required for intercontroller Layer 3 roaming?
- A . Mobility groups are established between wireless controllers.
- B . The management VLAN is present as a dynamic VLAN on the second WLC.
- C . WLCs use separate DHCP servers.
- D . WLCs have the same IP addresses configured on their interfaces.
An engineer configures GigabitEthernet 0/1 for VRRP group 115. The router must assume the primary role when it has the highest priority in the group.
Which command set is required to complete this task?
interface GigabitEthernet0/1
ip address 10.10.10.2 255.255.255.0
vrrp 115 ip 10.10.10.1
vrrp 115 authentication 407441579
- A . Router(config-if)# vrrp 115 priority 100
- B . Router(config-if)# standby 115 priority 100
Router(config-if)# standby 115 preempt - C . Router(config-if)# vrrp 115 track 1 decrement 10
Router(config-if)# vrrp 115 preempt - D . Router(config if)# vrrp 115 track 1 decrement 100
Router(config-if)# vrrp 115 preempt
An engineer must configure AAA on a Cisco 9800 WLC for central web authentication.
Which two commands are needed to accomplish this task? (Choose two.)
- A . Option A
- B . Option B
- C . Option C
- D . Option D
- E . Option E
What is a benefit of Type 1 hypervisors?
- A . Administrators are able to load portable virtual machine packages in OVA or QCOW2 formats.
- B . Network engineers are able to create virtual networks o interconnect virtual machines in Layer 2 topologies
- C . Operators are able to leverage orchestrators to manage workloads that run on multiple Type 1 hypervisors
- D . Storage engineers are able to leverage VMDK files to provide storage to virtual machine.
What is the wireless received signal strength indicator?
- A . The value given to the strength of the wireless signal received compared to the noise level
- B . The value of how strong the wireless signal Is leaving the antenna using transmit power, cable loss, and antenna gain
- C . The value of how much wireless signal is lost over a defined amount of distance
- D . The value of how strong a tireless signal is receded, measured in dBm
DRAG DROP
Drag and drop characteristics of PIM dense mode from the left to the right.
Refer to the exhibit.
After an engineer configures an EtherChannel between switch SW1 and switch SW2, this error message is logged on switch SW2.
Based on the output from SW1 and the log message received on Switch SW2, what action should the engineer take to resolve this issue?
- A . Configure the same protocol on the EtherChannel on switch SW1 and SW2.
- B . Connect the configuration error on interface Gi0/1 on switch SW1.
- C . Define the correct port members on the EtherChannel on switch SW1.
- D . Correct the configuration error on interface Gi0/0 switch SW1.
Which antenna type should be used for a site-to-site wireless connection?
- A . Omnidirectional
- B . dipole
- C . patch
- D . Yagi
Latest 350-401 Dumps Valid Version with 404 Q&As
Latest And Valid Q&A | Instant Download | Once Fail, Full Refund
Question 91 has a wrong answer marked s correct. The answer is B.
BPDU filter is the only option to block BPDUs while not going inte err disabled when a BPDU is received.
https://www.exam4training.com/which-command-set-must-be-configured-on-switch1-to-achieve-the-following-results-on-port-fa0-1/
https://www.cisco.com/en/US/docs/switches/metro/me3600x_3800x/trash/swstpopt.html#:~:text=The%20BPDU%20filtering%20feature%20can,bpdufilter%20default%20global%20configuration%20command.