Cisco 300-510 Implementing Cisco Service Provider Advanced Routing Solutions (SPRI) Online Training
Cisco 300-510 Online Training
The questions for 300-510 were last updated at Sep 08,2025.
- Exam Code: 300-510
- Exam Name: Implementing Cisco Service Provider Advanced Routing Solutions (SPRI)
- Certification Provider: Cisco
- Latest update: Sep 08,2025
Refer to the exhibit.
Router 1 has attempted to establish a Cisco MPLS TE tunnel to router 2, but the tunnel has failed.
Which statement about this configuration is true?
- A . Router 1 must define an explicit path to router 2
- B . Router 1 and router 2 must define the RSVP bandwidth reserved on the physical interfaces
- C . Router 2 must have a tunnel interface created with router 1 as the destination
- D . Router 1 must have Cisco MPLS TE enabled on interface gigabitethernet0/1
Refer to the exhibit
Which router does R1 install as an alternate next hop when trying to reach R3 if LFA is enabled?
- A . R5
- B . R3
- C . R4
- D . R2
Refer to the exhibit.
Routers R1 and R2 cannot form a neighbor relationship, but the network is otherwise configured correctly and operating normally.
Which two statements describe the problem? (Choose two.)
- A . The two routers are in the same area
- B . The two routers are in different subnets
- C . The two routers have password mismatch issues
- D . The two routers have the same network ID
- E . The two routers are in different areas
Refer to the exhibit.
P1 and PE3 Cisco IOS XR routers are directly connected and have this configuration applied. The BGP session is not coming up. Assume that there is no IP reachability problem and both routers can open tcp port 179 to each other.
Which two actions fix the issue? (Choose two.)
- A . Change MD5 to HMAC-SHA1-12
- B . Change MD5 to HMAC-ESP
- C . Change MD5 to SHA-1
- D . Change MD5 to HMAC-MD5
- E . Remove the send and accept lifetime under key 1
Which command is used to enable BIDIR-PIM under global configuration mode for Cisco IOS XE Sofware?
- A . ip pim bidir-enable
- B . ipv4 pim bidir-enable
- C . ip multicast-routing
- D . ip pim bidir
Which output from the show isis interface command helps an engineer troubleshoot an IS-IS adjacency problem on a Cisco IOS-XR platform?
- A . metric
- B . priority
- C . circuit type
- D . hello interval
A network engineer is troubleshooting OSPF multiare A.
Which Cisco IOS XR feature should the engineer use in order to streamline OSPF issue?
- A . hierarchical CLI
- B . DR support for topology management
- C . routing process enabled by default on all interfaces
- D . show ip ospf topology command
Refer to the exhibit.
After troubleshooting BGP traffic steering issue, which action did the network operator take to achieve the correct effect of this configuration?
- A . Routes that have passed through AS 65517 have the local preference set to 150.
- B . Routes that have originated through AS 65517 have the local preference set to 150.
- C . Routes directly attached to AS 65517 have the local preference set to 150.
- D . Routes that have passed through AS 65517 have the local preference set to 150 and the traffic is denied.
For which reason can two BGP peers fail to establish a neighbor relationship?
- A . Their BGP send-community strings are misconfigured
- B . Their BGP timers are mismatched
- C . Their remote-as numbers are misconfigured
- D . They are both activated under an IPv4 address family
In a PIM-SM environment, which mechanism determines the traffic that a receiver receives?
- A . The receiver explicitly requests its desired traffic from the RP on the shared tree.
- B . The receiver explicitly requests traffic from a single source, which responds by forwarding all traffic.
- C . The RP on the shared tree floods traffic out of all PIM configured interfaces.
- D . The receiver explicitly requests traffic from each desired source, which responds by sending all traffic.
Latest 300-510 Dumps Valid Version with 103 Q&As
Latest And Valid Q&A | Instant Download | Once Fail, Full Refund
