Cisco 300-365 Deploying Cisco Wireless Enterprise Networks Online Training

Cisco 300-365 Online Training

The questions for 300-365 were last updated at Oct 13,2025.

Exam Code: 300-365
Exam Name: Deploying Cisco Wireless Enterprise Networks
Certification Provider: Cisco
Latest update: Oct 13,2025

Question #41

A customer has "quiet" wireless clients that use static IP addresses.

Which two WLAN configurations are required for these wireless clients to connect properly? (Choose two.)

A . Disable DHCP address assignment required.
B . Enable passive client.
C . Disable allow AAA override.
D . Enable static IP tunneling.
E . Disable DHCP server override.

Reveal Solution Hide Solution

Question #42

A wireless engineer at a convention center has been asked to provision an SSID that can accommodate 4,000 users during a conference.

Which interface group configuration should be used?

A . One interface with /20 mask
B . Two interfaces with /21 mask
C . Four interfaces with /22 mask
D . Eight interfaces with /23 mask

Reveal Solution Hide Solution

Question #43

A customer recently implemented WLC wireless multicast. Clients and connecting at the highest mandatory wireless rate of 24 Mbps and are receiving multicast traffic, but WLC cpu utilization and wired side network load has increased substantially.

What three actions should the engineer take next to optimize the configuration? (Choose Three) A. verify that Global Multicast mode has been enabled

B. verify that IGMP snooping is disabled on the wireless controller since the access points are handing IGMP messages from the clients.

C. make sure the highest mandatory rate is set to 54 Mbps so that the multicast traffic has sufficient bandwidth

D. verify Multicast Listener Discovery (MLD) v1 snooping has been enabled to keep track of and deliver IPv4 multicast flows

E. change the wireless controller from Multicast-Unicastmodeto Multicast-Multicast mode and assign a multicast address in the 239.X.X.X/8 subnet

F. verify that the L3 interfaces are configured for pirn sparse-dense-mode on the VLAN servicing the wireless access points as well as the wireless controller’s management VLAN

Reveal Solution Hide Solution

Question #44

CMX Facebook WiFi can allow access to the network before authentication.

Which two of the following options are available? (Choose two)

A . Allow all the traffic before authentication and intercept HTTPs only.
B . Allow HTTP traffic only before authentication and block all the traffic.
C . Allow SNMP traffic only before authentication and block all the traffic.
D . Allow all the traffic before authentication and intercept HTTP only.
E . Allow HTTPs traffic only before authentication and block all other traffic.

Reveal Solution Hide Solution

Question #45

You have set up FlexConnect APs. For which scenario is Fast Roaming supported, providing the WLAN is mapped to the same VLAN and the client is roaming to an AP on the same Cisco WLC?

A . central switching with PMK (OKC) between different FlexConnect groups
B . local switching with Cisco Centralized Key Management within the same FlexConnect group
C . central switching with Cisco Centralized Key Management between different FlexConnect groups
D . local switching with PMKID within the same FlexConnect group

Reveal Solution Hide Solution

Question #46

A customer has implemented a N+1 high availability plan in a multistory building. All APs on odd numbered floors are set as primary to WLC-A and all APs on even numbered floors are set as primary to WLC-8.

Which two problems are likely to arise from this design? (Choose two)

A . inconsistent CleanAir data due to multiple WLCs
B . floor-to-floor bleed-through that causes intercontroller roaming delays
C . AVC inconsistency due to multiple mobility group members
D . legacy device compatibility with multiple WLC configuration that causes disconnects
E . unpredictable AP loading during a WLC failure

Reveal Solution Hide Solution

Question #47

CORRECT TEXT

Scenario

One of your colleagues has setup a test network in the lab to simulate a new building atone of your regional offices. Your team is testing AP failover. Your colleague has requested you to configure the WLCs so that in the event of a loss of one of the WLCsthe other wings APs will fail over to the remaining WLC.

The APs on the East-WLC-2504A should fail over to the West-WLC2-2504A, and the APs on the West-WLC2-2504A should fail over to the East-WLC-2504A.

Set the priority of the APs so the backup controller recognizes the join request from the higher-priority AP and if necessary disassociates a lower-priority AP to provide access to an available port.

Not all menus, tabs and features are supported.

Topology

Reveal Solution Hide Solution

Question #48

What are two functions of the RAP in a mesh network? (Choose two.)

A . It provides a wired connection for the wireless mesh APs.
B . It adds capacity and resilience to a mesh area.
C . it creates a centralized management location for the mesh network.
D . it reduces the hop count to the wireless network that is connected to the edge.
E . it routes traffic from the wireless mesh to the wired network.

Reveal Solution Hide Solution

Question #49

A customer requires that the remote site be able to utilize local servers when the AP is in WAN-

down (standalone mode).

Which AP mode must be configured on the wireless controller?