Cisco 300-360 Designing Cisco Wireless Enterprise Networks Online Training
Cisco 300-360 Online Training
The questions for 300-360 were last updated at Sep 09,2025.
- Exam Code: 300-360
- Exam Name: Designing Cisco Wireless Enterprise Networks
- Certification Provider: Cisco
- Latest update: Sep 09,2025
Refer to the exhibit.
Which type of cable connector is displayed that is used to connect antennas to transmitters?
- A . RP-TNC
- B . N
- C . SMA
- D . SMB
- E . MMCX
A customer is having issues streaming video over wireless in a few high-density areas of their campus. After further investigation, the administrator has singled out the issue pertains to the clients associated to 802.11b/g only access points. The rest of the campus is covered in 802.11n access points.
What is a possible reason for the issue with video streaming on the 802.11b/g access points as opposed to the 802.11n access points?
- A . Due to the High-Density environment, there was high-utilization of the wireless spectrum. With 802.11n. the access points are able to aggregate the MSDU and MPDU frames into A-MSDU and AMPDU frames, utilizing less airtime to transfer data.
- B . The wireless clients were all transmitting at 802.11b data rates and would have operated properly had they been transmitting and receiving at 802.11g rates.
- C . The clients could not transmit data at the highest mandatory rate of 54 Mbps due to limitations with 802.11b/g. This data-rate is only possible when transmitting at 802.11n speeds.
- D . The wireless controller was denying the client access to the video due to multicast-direct supporting the PHY rate of 48000 that the 802.11b/g client could not handle.
Which two critical requirements must be addressed in the RF site survey for wireless video surveillance? (Choose two.)
- A . packet loss
- B . jitter
- C . bandwidth
- D . channel selection
- E . WLC configuration
When designing a large, high-availability wireless network, what changes to a mobility- group would create less load on the controllers while maintaining the same mobility messages?
- A . remove unnecessary controllers from the mobility-group to cut down on the controller’s messaging load
- B . separate the controllers into different mobility-groups per controller to only send relevant messaging to controllers in different groups
- C . configure mobility-group multicast messaging
- D . configure the controllers into separate RF-Groups from the mobility-groups to cut down on controller processing load
After enabling global multicast, multicast traffic has been flooding the wired and wireless network. The wireless engineer has been troubleshooting and is attempting to find the source of the traffic.
What command will display the multicast traffic source as well as the incoming interface?
- A . show ip mroute
- B . show ip igmp groups
- C . show ip pim neighbor
- D . show ip device tracking all
Which piece of information gathered during a WLAN site survey should be included in the customer report?
- A . Analysis of server location and applications supported.
- B . Analysis of fiber-optic backbone infrastructure.
- C . Output from Cisco WCS Location Quality Inspector.
- D . Output from Cisco WCS VoWLAN Voice Readiness Tool.
- E . Output from Cisco WCS Planning Mode Tool.
Which three statements describe WLAN RF interaction with environmental situations? (Choose three.)
- A . Outdoor rain or indoor humidity affects diffraction.
- B . Outdoor rain or indoor humidity affects attenuation.
- C . RF frequency is inversely related to attenuation.
- D . RF frequency is directly related to attenuation.
- E . The human body affects diffusion.
- F . The human body affects attenuation.
A network engineer is having wireless multicast fail when it hits the wired network.
What command will show the source of multicast groups for troubleshooting?
- A . show ip igmp
- B . show ip mroute
- C . show ip mcache
- D . show ip interface counts
- E . show ip route
Which two basic characteristics would be needed from antennas used for survey and deployment in various indoor situations? (Choose two.)
- A . Horizontally polarized
- B . Vertically polarized
- C . Aesthetically fitting
- D . Least cost
- E . Highest gain F. Largest beam width
Latest 300-360 Dumps Valid Version with 221 Q&As
Latest And Valid Q&A | Instant Download | Once Fail, Full Refund
