Cisco 200-310 Designing for Cisco Internetwork Solutions Online Training
Cisco 200-310 Online Training
The questions for 200-310 were last updated at Oct 23,2025.
- Exam Code: 200-310
- Exam Name: Designing for Cisco Internetwork Solutions
- Certification Provider: Cisco
- Latest update: Oct 23,2025
What are two advantages of employing scalability when designing a campus network? (Choose two.)
- A . reduces operational cost
- B . higher port density
- C . investment protection
- D . consistent operation
- E . improved fault tolerance
A network engineer is using the traditional switched hierarchical design. The client has asked to increase uplink utilization from the access layer to the distribution.
How can the engineer attain this new requirement without adding new physical connections?
- A . enable spanning-tree portfast
- B . enable VSS at the distribution layer
- C . increase the MTU size on the uplink interfaces
- D . ensure the root bridge priority is equal on both distribution switches
Multicast has been enabled and configured in the Enterprise, and PIM Sparse-mode has been enabled on all VLANs.
What feature is required to stop multicast traffic from being broadcasted on the access layer switches?
- A . IGMP snooping
- B . Multicast boundary filter
- C . PIM dense-mode
- D . Dynamic ARP inspection
What two SAN protocols will allow a customer to utilize 10GbE for SAN access? (Choose two.)
- A . ISCSI
- B . FCoE
- C . SATA
- D . Fiber Channel
- E . AoE
Application servers require load balancing and security services.
Where in the data center network should these services be provisioned?
- A . core
- B . aggregation
- C . Layer 3 access
- D . distribution
A data center is reaching its power and cooling capacity.
What two virtualization technologies can address the problem by directly reducing the number of physical devices? (Choose two.)
- A . virtual switching systems
- B . virtual device contexts
- C . virtual servers
- D . virtual routing and forwarding
- E . virtual port channels
- F . virtual LANs
A dynamically routed private line and a statically routed IPsec tunnel connect two offices.
What routing configuration prefers the IPsec tunnel only in the event of a private line failure?
- A . floating static entry
- B . EIGRP variance
- C . bandwidth metric
- D . OSPF maximum paths
When designing a new enterprise campus network, what topology should be used for maximum scalability?
- A . flat
- B . three-layer
- C . star
- D . partial mesh
- E . full mesh
A spanning tree topology can be simplified by deploying what Cisco IOS technology in the distribution block?
- A . VDC
- B . vPC
- C . Rapid PVST+
- D . VSS
- E . Flex Links
An organization is deciding what routing protocol to use throughout their network.
What must be considered if routing is to be performed at the access layer?
- A . reduced scalability of the network when introducing a large number of switch blocks into the routing table
- B . centralized management of access control lists at the distribution layer
- C . reliability when implementing routing over spanning-tree at the access layer
- D . performance differences between core, distribution and access layer equipment
Latest 200-310 Dumps Valid Version with 644 Q&As
Latest And Valid Q&A | Instant Download | Once Fail, Full Refund
