Cisco 200-310 Designing for Cisco Internetwork Solutions Online Training
Cisco 200-310 Online Training
The questions for 200-310 were last updated at Oct 19,2025.
- Exam Code: 200-310
- Exam Name: Designing for Cisco Internetwork Solutions
- Certification Provider: Cisco
- Latest update: Oct 19,2025
DRAG DROP
Match the bandwidth usage optimization technique on the left with its definition on the right.
Which two routing protocols usually converge most quickly? (Choose two.)
- A . RIPv1
- B . RIPv2
- C . BGP
- D . OSPF
- E . EIGRP
Which two routing protocols operate over NBMA point-to-multipoint networks without the use of point-topoint sub interfaces? (Choose two.)
- A . RIPv1
- B . RIPv2
- C . IS-IS
- D . EIGRP
- E . OSPF
Refer to the exhibit.
Which three modules would typically utilize public IPv4 addressing? (Choose three.)
- A . Access
- B . Distribution
- C . Core
- D . Data Center
- E . E-Commerce
- F . Internet Connectivity
- G . Remote Access/VPN
- H . WAN/MAN
- I . Branch
- J . Branch Data Center
With respect to IPv6 addressing, from a design perspective, which of these statements is it important to keep in mind?
- A . IPv6 addressing provides convenience of anycast addressing without any configuration requirements.
- B . IPv6 does not use multicast addressing.
- C . An IPv6 router will not forward packets from one link to other links if the packet has either a link-local source or a link-local destination address.
- D . Dynamic address assignment requires DHCPv6.
Which consideration is the most important for the network designer when considering IP routing?
- A . convergence
- B . scalability
- C . on-demand routing
- D . redistribution
Your supervisor has asked you to deploy a routing protocol within the lab environment that will allow for unequal cost multipath routing.
Which should you choose?
- A . EIGRP
- B . OSPF
- C . IS-IS
- D . RIP
Which two methods are used to reduce the mesh links required between iBGP peers in the same AS? (Choose two.)
- A . community
- B . router reflectors
- C . local preference
- D . confederations
- E . atomic aggregate
- F . MED
A company wants to use private IP addresses for all its internal hosts.
Which technology can the company use to provide access to the Internet using a single public IP address?
- A . static NAT
- B . source routing
- C . ACL
- D . PAT
At which layer of the network is route summarization recommended?
- A . data link layer
- B . core layer
- C . distribution layer
- D . access layer