Which EtherChannel mode must be configured on the switch to allow the WLC to connect?

350-401 1 Comment

To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.

Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A . Auto
B . Active
C . On
D . Passive

Answer: B

Latest 350-401 Dumps Valid Version with 404 Q&As

Latest And Valid Q&A | Instant Download | Once Fail, Full Refund

Instant Download 350-401 PDF     350-401 Questions Online Training
Subscribe
Notify of
guest
1 Comment
Inline Feedbacks
View all comments
Khaled
Khaled
4 years ago

Mode on, so the right answer is C :

The controller’s neighbor devices must also be properly configured to support LAG
Each neighbor port to which the controller is connected should be configured as follows:
interface GigabitEthernet
switchport
channel-group mode on
no shutdown

https://community.cisco.com/t5/wireless-mobility-documents/lag-link-aggregation/ta-p/3128669

0
Reply